Thermal Cooling with Sprinklers or Microsprinklers Reduces Heat Damage and Improves Fruit Quality in Northern Highbush Blueberry.

Hot and sunny weather can cause a considerable amount of fruit damage in northern highbush blueberry (Vaccinium corymbosum L.) and result in millions of dollars of crop loss each year. To combat this issue, many growers use over-canopy sprinkler or microsprinkler systems to cool the fruit, but questions remain on the amount of time and frequency these systems should be run and whether they have any effect on fruit quality. Two series of studies were conducted to evaluate the efficacy of using sprinklers or microsprinklers for reducing blueberry fruit temperature and improving fruit quality in western Oregon. With sprinklers, treatments were applied in 2014 and 2015 to 'Elliott' blueberry and included irrigation (night) and cooling (day) with sprinklers, sprinkler irrigation (at night only) with no cooling, and drip irrigation with no cooling. The sprinklers were run for cooling for 15 minutes every hour whenever air temperature was ≥32 or 35 8C. Berry temperature declined rapidly within the first 15 minutes of cooling and never exceeded ambient air temperature during the cooling cycles. While the percentage of fruit with heat damage was low even without cooling (<2%), cooling reduced damage to nearly 0% in 1 of 2 years and increased berry weight relative to no cooling in both years when it was run at ≥32 °C. Cooling also reduced the concentration of soluble solids (sugars) in the berries in 2014 but had no effect on yield, fruit firmness, titratable acidity, harvest date, or the total content of phenolics or anthocyanins in the berries in either year. With microsprinklers, cooling was tested at a commercial farm and at an experimental site. At the farm, 1.3-ha blocks of 'Aurora' blueberry were irrigated by drip and either had no cooling or were cooled using microsprinklers run continuously or pulsed in 1-hour or 20- minute cycles during three extreme heat events (≥35 °C) in 2015. Continuous cooling was the most effective treatment for reducing berry temperature, but it resulted in wetter conditions, which might impede fruit harvest afterward and increase the presence of slugs, insect pests, and fungal diseases. Pulsed cooling, especially with short cycles, effectively maintained fruit temperatures near that of ambient air and reduced water use by 50%. At the experimental site, cooling with microsprinklers, which in this case were pulsed in 20- min cycles when air temperature was ≥ 32 °C, reduced heat damage in 'Aurora' and 'Elliott' in 2016. Cooling at this site also increased berry weight by an average of 10% in both cultivars and increased fruit firmness by 32% during the first of three harvests in 'Aurora'; however, it reduced the concentration of soluble solids in the berries in both cultivars. In general, cooling with microsprinklers used considerably less water than cooling with sprinklers, but it appeared to be equally effective at reducing berry temperature. [ABSTRACT FROM AUTHOR]