Numerical analysis of single-phase liquid immersion cooling for lithium-ion battery thermal management using different dielectric fluids.

• A numerical analysis is performed for direct liquid cooling of lithium-ion batteries using different dielectric fluids. • Study and compared the thermal performance of three different dielectric fluids including mineral oil, deionised water, and one engineered fluid. • The temperature rise is limited to below 3 °C for 1c- discharge by using deionised water at all mass flow rates, where oil-based fluids are delivering better performance only at higher mass flow rates of 0.05 kg/s. • The mineral oil and engineered fluids deliver almost an equal thermal performance, however, the latter consumed 76.43% less power at a mass flow rate of 0.05 kg/s. Lithium-ion battery (LIB) cells are responsible for powering most electric vehicles. LIB is still a superior battery available in the market because of its high energy density, specific power, and long cycle life. However, LIB comes with the challenges like thermal management as it is highly sensitive to temperature. Amongst different cooling methods, direct liquid cooling, also known as immersion cooling, can deliver a high cooling rate mainly because of its complete contact with the heat source. The single-phase liquid immersion with dielectric fluids (DELC) offers safety and cooling performance with lower parasitic power consumption and space requirements. This research involves studying and comparing different DELC's for the direct cooling of lithium-ion batteries. A numerical analysis of the 4S1P arrangement of LIB cells with direct cooling is conducted with three different DELC's including deionised water, mineral oil, and an engineered fluid. The transient behaviour of the battery module for various mass flow rates of DELC and at 1C,2C,3C-discharge rates are examined. All DELC maintains an excellent temperature homogeneity within the individual cells and LIB cells. The DELC with higher specific heat and thermal conductivity is suitable for cooling the LIB cells during high discharge conditions. However, all the dielectric fluids studied here effectively limit the temperature rise below 5 °C at 2-C discharging operation when the mass flow rate is increased to 0.05 kg/s. This improvement in thermal performance comes at the expense of extra power consumption. Even though both DELC-2 and DELC -3 delivered almost similar temperature rise values of 6.1, 5.2 °C, respectively during 2C discharging operation, the latter consumed 76.43% less power at a mass flow rate of 0.05 kg/s. For this reason, engineered fluids with lower viscosity values can be preferred over mineral oils. The deionised water is more effective for limiting the temperature rise below 2.2 °C for 3C discharging with the least parasitic power consumption of 0.52 mW at a mass flow rate of 0.05 kg/s. A variable cyclic load matching HWFET-driving cycle has been applied to the battery pack with all three DELCs, and all three fluids limited temperature rise below 1 °C. [ABSTRACT FROM AUTHOR]