Extracting high-resolution, multi-mode surface wave dispersion data from distributed acoustic sensing measurements using the multichannel analysis of surface waves.

Distributed acoustic sensing (DAS) is a rapidly expanding tool to sense wave propagation and system deformations in many engineering applications. In terms of site characterization, DAS presents the ability to make dynamic strain measurements at scales (e.g., kilometers) and spatial resolutions (e.g., meters) that were previously unattainable with traditional measurement technologies. In this study, we use both vibroseis truck and sledgehammer sources to demonstrate that DAS can be used to make multichannel analysis of surface waves (MASW) dispersion measurements that are equivalent in quality to geophones when: (a) a tight-buffered or strain-sensing fiber-optic cable is used, (b) the cable is buried in a shallow trench to enhance coupling, and (c) short gauge lengths and small channel separations are used. We analytically demonstrate the impact gauge length has on DAS measurements in terms of phase and amplitude for off-end MASW surveys. We further show that the choice of waveform units (i.e., phase, strain, strain-rate, displacement, velocity) do not impact the dispersion results when frequency-dependent normalization is applied to the dispersion images. Finally, we show that shear wave velocity profiles recovered from the DAS data using an uncertainty-consistent, multi-mode inversion agree favorably with cone penetration tests performed at the site. This study demonstrates that DAS, when appropriate considerations are made, can be used instead of traditional sensors (i.e., geophones) for making high-resolution, multi-mode measurements of surface wave dispersion data using the MASW technique. • DAS and geophones measurements can be compared directly in terms of dispersion. • Short wavelength DAS measurements are strongly limited by the system's gauge length. • Vs inverted from DAS-derived dispersion agrees favorably with invasive results. • DAS can be used in-lieu of traditional sensors for making dispersion measurements. [ABSTRACT FROM AUTHOR]