Experimental study on mixed mode-I & II bond behavior of CFRP-to-steel joints with a ductile adhesive.

Utilizing ductile adhesive on CFRP-reinforced steel structures makes the bonded interface with good resistance to dynamic and fatigue loading, which is suitable for the rehabilitation of steel bridges. Currently, considerable studies on the aspect of the CFRP–steel interface are focused only on mode-II loading, ignoring the effects of mode-I loading which could lead to a catastrophic collapse of the retrofitted structures. In the present paper, modified CFRP-to-steel bonded double overlapped joints with various initial peeling angles (θ) were manufactured in order to consider mode-I loading and study the bond behavior of CFRP-to-steel joints under mixed mode-I&II loading. The results showed that the bonded side with weaker adhesion between CFRP and adhesive debonded first and presented a CFRP-adhesive interfacial debonding mode, while the debonding of the other side was delayed and showed a cohesive failure mode in the adhesive. The bond shear stress vs. slip relationship of the debonded side showed to have a bi-linear trend in which the bond strength and interfacial fracture energy were low whilst the other side showed a trapezoidal relationship with a constant plastic plateau and with higher interfacial fracture energy. It was found that sudden debonding caused a quick propagation in the CFRP strain as well as on the global interfacial slip of the joints. It was also found that the peeling angle had significantly deteriorated the local bond response in mode-II, i.e. the trapezoidal bond shear stress vs. slip relationship in the joints with θ = 0 ° shifted to a bi-linear relationship in the joints with θ = 1 ° , θ = 2 ° and with θ = 3 ° in which the bond strength, slip and fracture energy, all decreased very much. Moreover, with θ = 4 ° was experimentally determined as the threshold angle from which the associated mode-I loading can, per se , separate the CFRP from steel. • A review of the bond behavior of CFRP-to-steel joints subjected to mode-I, mode-II and mixed mode-I&II loading is presented. • Modified CFRP-to-steel bonded joints were conceived, allowing assessment of the bond behavior considering mode-I loading. • Different bond qualities in both sides of the CFRP-to-steel double overlapped joints were identified. • Influences of the initial peeling angles on the bond performance of the CFRP-to-steel joints were analyzed thoroughly. • Degradation of bond shear stress vs. slip response due to mode-I loading was experimentally observed. [ABSTRACT FROM AUTHOR]