Compressive behaviour of stiffened thin-walled CFDST columns with large hollow ratio.

Concrete-filled double skin steel tubular columns with large hollow ratio (LHR-CFDST) have been commonly used in recent years. With the increasing size of the engineering structures, one efficient way to decrease the consumption of steel is to increase the diameter-to-thickness ratio. Few studies have been conducted to report on thin-walled LHR-CFDST columns. At the same time, local buckling may occur in these structures in the absence of stiffening measures. Based on this, an experimental and numerical analysis was carried out for the stiffened thin-walled LHR-CFDST columns under axial compression in this paper. Five thin-walled LHR-CFDST columns with different stiffening measures (ribs, studs) were tested. The failure modes, load versus shortening curves, local buckling behaviours and ductility were investigated. The test results indicates that the stiffened measures effectively delayed the appearance of local buckling and increased the peak load. Besides, the finite element models validated by the test results were applied to the subsequent mechanical mechanism analysis of the stiffened thin-walled LHR-CFDST. It can be seen that the stiffened measures enhance the confinement of the inner and outer steel tubes on the concrete and greatly improve the ultimate strength of the concrete. Finally, the predicted peak load formulae in the existing design specifications were modified by combining the characteristics of the specimens in this paper. The peak load values obtained by the improved formulae agreed well with the test results. • Five thin-walled CFDST columns with different stiffening forms (ribs, studs) were tested under axial compression. • The effects of stiffeners on the local buckling and peak load of specimens were revealed. • The validated finite element model was developed to further analyze the structural mechanisms. • The interaction between steel tubes and concrete were investigated. • The predicted peak load formulae in the existing design specifications were modified. [ABSTRACT FROM AUTHOR]