Simulation of wellbore temperature and heat loss in production well in geothermal site.

Knowledge of fluid flow temperature along the wellbore can be useful for a realistic calculation of the total heat production in geothermal wells. Therefore, wellbore modeling is an important part of the characterization of geothermal wells and predicting their future behavior. This study describes the dynamic transport of transient heat and fluid dynamic transport inside a geothermal well and also heat loss in the surrounding rocks. The objective of this investigation is to accurately predict temperature and pressure variations within the producing well GPK2 of the geothermal site Soultz-sous-Forêts. The temperature effect of possible leakage zones in the reservoir section of the production casing was also considered. A single-phase flow modeling was carried out using Comsol software. Our study highlights that the properties of the flow (well flow rates for steady and unsteady flow), of the fluid (density, viscosity, chemical composition), and the well (diameter, length, thermal properties of environments) are parameters, which directly influence the pressure and temperature profiles of the well. A sensitivity study has been carried out to demonstrate the role that these parameters play in the heat transport occurring in this well. According to our simulated results, during the flow of hot water in GPK2 well the production temperature of water decreases by dozen degrees of its downhole temperature. It is also shown that the leakage zone affects the temperature, decreasing it at least by 1–2°C. [ABSTRACT FROM AUTHOR]