Experimental investigation and intelligent modeling of pore structure changes in type III kerogen-rich shale artificially matured by hydrous and anhydrous pyrolysis.

The occurrence and enrichment of shale plays are highly controlled by pore characteristics of the formation. In this study, an immature sample rich in kerogen type III from the Damoguaihe formation, Hailar Basin in China is subjected to hydrous and anhydrous pyrolysis (HP and AHP) across an extensive temperature range (300–450 °C). Next, low-pressure N 2 adsorption analysis was conducted on the pyrolyzate of each maturity stage to study the pore structures' evolution during thermal maturity simulation. Moreover, deconvolution and fractal dimension analyses were implemented to study pore families and the complexity of pores within the shale samples. Finally, radial basis function (RBF) neural networks optimized by four evolutionary approaches were applied for modeling N 2 adsorption data obtained from the HP and AHP samples. According to the results, the original shale sample and all pyrolyzates obtained with HP and AHP scenarios exhibited type IV isotherm with H3 hysteresis loops. As a whole, BET surface area, micro-, meso- and total pore volume of HP pyrolyzates were higher than AHP ones. The unheated shale sample had seven families containing three mesopore and four macropore groups. Although all pyrolyzates obtained from the pyrolysis had families with similar means, their pore volumes were entirely different, which proves that the pore structure of samples undergoes changes during thermal maturation and the presence of water can also enforce these changes. Both fractal dimensions showed a direct relationship with BET surface area and a negative correlation with the average pore diameter of shale samples. The RBF model optimized by differential evolution (DE) delivered a mean absolute percent relative error (MAPRE) value of 4.84% and determination coefficient (R2) of 0.9946 for the total data set, which outperforms other RBF models in predicting N 2 adsorption/desorption tests of pyrolyzates. The outcome of sensitivity analysis suggested that the N 2 adsorption/desorption behavior of the pyrolyzates was mostly affected by relative pressure and the pyrolysis type (HP or AHP). Ultimately, the results clearly revealed that the effect of water on the pores' alteration of shales with type III kerogen is greater than the effect of temperature or thermal maturity itself. • An immature kerogen type III sample from Damoguaihe formation is subjected to HP and AHP tests. • Original and all artificially matured samples exhibited type IV isotherm with H3 hysteresis loops. • BET surface area, micro-, meso- and total PV of HP samples were higher than AHP ones. • The RBF AI model optimized by DE outperformed other RBF models in predicting N 2 adsorption/desorption. • N 2 adsorption/desorption is affected by relative pressure and pyrolysis pathway, the most, among all parameters. [ABSTRACT FROM AUTHOR]