Tribo-Electric Analysis of Multi-Cycle Wear in Asymmetric Laser-Structured Cu-Sn Connectors.

One of the key objectives of the connector industry for the past years has been to reduce the insertion friction forces of detachable electrical connections, where the majority of approaches combine a particular connector design with the usage of lubricants. The necessity for a solution that uses less contact force to maintain a lasting electrically conductive connection without sacrificing the mechanical robustness of the connection during use is a significant challenge in this situation. The approach in this work is to create surfaces supporting asymmetric friction, meaning lower insertion than removal forces. By Direct Laser Interference Patterning (DLIP), asymmetric saw-tooth structures with different structural inclinations and periodicities were generated on Sn-coated Cu plates. It is determined that topographical interlocking is the primary operating mechanism providing the required anisotropy. Multiple insertion/removal cycles were simulated on the tailored surfaces to tribologically characterize them and to determine the evolution of the electrical contact resistance at the end of each insertion motion. The vast majority of the generated structures showed an improvement compared to the reference state, with lower insertion and higher removal forces while the electrical behavior is not significantly impacted. [ABSTRACT FROM AUTHOR]