Characterisation of the transverse shear behaviour of binder-stabilised preforms for wind turbine blade manufacturing.

Binder-stabilised preforms are being used increasingly in the production of large composite structures, such as wind turbine blades, to increase the throughput. The transverse shear behaviour of the preform is one of the driving factors in the development of wrinkling during manufacturing but has not previously been characterised in the literature. In this paper, the combined intra- and inter-ply deformations during transverse shearing of a binder-stabilised preforms for wind turbine blade manufacturing are characterised by a new test methodology. The results from two experimental campaigns are presented. In the first campaign, preform specimens are subjected to monotonic loading to a nominal transverse shear angle of 18.0° with three different deformation rates. The results show an increase in maximum load levels with greater deformation rates. In the second campaign, preform specimens are subjected to deformation-controlled cyclic loading with two different deformation amplitudes corresponding to a nominal transverse shear angle of 1.5° and 12.2°, respectively. During cyclic loading, permanent deformation is observed in all preform specimens and the maximum load at the 19th cycle is reduced to 48% of the maximum load at the first cycle for the tests with deformation amplitudes of 12.2°. The data generated in this study is freely available at https://doi.org/10.17632/9m78sg3zwn.1. [ABSTRACT FROM AUTHOR]