Stress Release–Induced Suction in Unsaturated MX80 Bentonite Pellet and Powder Mixtures.

In this study, a series of suction-control oedometer tests were conducted on unsaturated and saturated MX80 bentonite pellet/powder mixtures. The mixture samples were imposed with various suctions from 0 to 113 MPa under a low vertical stress (0.1 MPa). Then, the mixture samples were loaded in steps with controlled suction until reaching three different target stresses σv (0.1, 3.2, and 12.8 MPa) and instantaneously unloaded. The microstructure of unloaded samples was observed with mercury intrusion porosimetry (MIP) and microcomputed tomography (μCT), together with the determination of suction, water content, void ratio, and saturation degree. Results showed that the water-retention behavior of bentonite pellet/powder mixture was rather characterized by pellets instead of powder. Due to the stress release, the measured suction after unloading sme was larger than the imposed suction sim. The suction difference Δs between sme and sim depended on both suction and load. Under a given σv , the suction effect was characterized by an increase of Δs when sim decreased from 113 to 4.2 MPa, but by a noticeable decrease of Δs when sim further decreased to zero. This was found to be related to the changes of the slopes of soil-water retention curves (SWRCs): the slope was decreasing with suction increases after 4.2 MPa suction, but was increasing with suction increases before 4.2 MPa suction. As far as the stress effect was concerned, a larger Δs was identified at a higher σv for a given sim. The narrowing difference between Δs and the reduction of mean stress of pellet Δppellet with increasing load was because of the decrease of larger pores due to loading. The total mixture void ratio eTmixture was highly dependent on suction and vertical stress, whereas the total pellet void ratio eTpellet was only dependent on suction in the stress range considered. [ABSTRACT FROM AUTHOR]