Pore-scale study of melting characteristic of phase change material embedded with novel open-celled metal foam.

• A novel porous structure based on truncated cuboctahedron is proposed. • The novel porous structure better enhances PCM melting near the porous cell corners. • A critical porosity exists to determine the enhancement advantages of two different porous structures. • The critical porosity is decreased with the increase of pore density. Metallic porous structure is a prevailing heat transfer enhancer for the melting of phase change material (PCM), while the effect of the structure on the enhancement performance is yet to be understood. In this work, a pore-scale numerical study on PCM melting embedded in a truncated cuboctahedron porous structure, referred as TCD metal foam, was performed. The solid–liquid interface, temperature and the variation of liquid fraction were analyzed and compared with those with the tetrakaidecahedron porous structure, referred as TKD metal foam. The effects of natural convection, porosity, pore density and heating temperature are explored. It is found the natural convection shortens the PCM melting time by about 7 % with the considered porosity range and thus cannot be ignored. Results also show that the TCD metal foam better enhances PCM melting near the porous cell corners compared to the TKD metal foam. Further analysis shows the TCD metal foam can better enhance melting at the former stage due to the larger surface area, while the TKD metal foam can better enhance melting at the later stage due to the thicker metallic ligaments. With essentially the same melting time at ɛ = 0.941, the half-melting takes 17.2 % of the complete melting time for TCD metal foam and 20.3 % of the complete melting time for TKD metal foam. A critical porosity value exists when comparing the enhancement performance of these two metal foams, below which the better melting enhancement is shifted from the case with TCD metal foam to the case with TKD one. The critical porosities are 0.941, 0.923 and 0.899 at the pore densities of 10, 20 and 30 PPI respectively. [ABSTRACT FROM AUTHOR]