Dual dynamic network structures of recyclable epoxy resins with high strength and toughness via sacrificial hydrogen-bonding clusters and imine bonds: surpassing the strength-toughness trade-off.

• Dual dynamic network structures of epoxy resins was prepared. • Scrificial hydrogen-bonding clusters (SHBC). • A new strategy to surpass the strength-toughness trade-off. • Rapid degradation and reprocessing capabilities. Thermosetting epoxy resins with high strength, high toughness, and recyclability are strongly sought after, but due to crosslinked structure, balancing strength and toughness and achieving degradation and reprocessing of resins is a challenge. Enhancing strength without compromising toughness during designing recyclable epoxy resin is a challenging task. Herein, a solution is demonstrated where isofluorodioxanone diisocyanate (IPDI), Poly (propylene glycol) bis(2-aminopropyl ether) (D230), and naturally occurring vanillin synthesized a novel imine-functionalized epoxy monomer (IDV-EP), and cured with diamino-diphenylmethane (DDM), 2-(4-aminophenyl)-1H-benzimidazol-5-amine (APBIA) and 4, 4-diamino benzoyl triphenylamine (DABA), respectively, for the purpose of building different contents of the sacrificial hydrogen-bonding clusters (SHBC) in topological network structures. As the hydrogen-bonding (H-bonding) binding energy of the crosslinked network increases, the strength and toughness of the resin were increased concurrently, SHBC was demonstrated to be a feasible method to achieve the strength-toughness trade-off of thermosets, in which IDV-EP-DABA illustrated a tensile strength of 90 MPa, an elongation at break of 16.5%, as well as toughness of 9.73 MJ/m3, which was higher than that of the ordinary bisphenol A-type epoxy thermosetting resin (DGEBA/DDM) by 1.8, 3.7 as well as 6.7 times, respectively. Furthermore, the covalent adaptive networks (CANs) formed by imine bonds provide the resins with effective capabilities for swift degradation (rapid degradation in acid/solvent, room temperature and static conditions) and reprocessing (only a slight decrease in the mechanical properties after hot pressed at 180°C/10 MPa for 15 minutes) , showcasing promising prospects for sustainable utilization. [ABSTRACT FROM AUTHOR]