Laboratory Tests on the Possibility of Using Flax Fibers as a Plant-Origin Reinforcement Component in Composite Friction Materials for Vehicle Braking Systems.

Braking systems are extremely important in any vehicle. They convert the kinetic energy of motion into thermal energy that is dissipated into the atmosphere. Different vehicle groups have different nominal and maximum speeds and masses, so the amount of thermal energy that needs to be absorbed by the friction pads and then dissipated can vary significantly. Conventional friction materials are composite materials capable of withstanding high temperatures (in the order of 500–600 °C) and high mechanical loads resulting from braking intensity and vehicle weight. In small vehicles traveling at low speeds, where both the amount of thermal energy and its density are limited, the use of slightly weaker friction materials with better ecological properties can be considered. This work proposes a prototype composite friction material using flax fibers as reinforcement instead of the commonly used aramid. A number of samples were prepared and subjected to laboratory tests. The samples were prepared using components of plant origin, specifically flax fibers. This component acted as reinforcement in the composite friction material, replacing aramid commonly used for this purpose. The main tribological characteristics were determined, such as the values of the coefficients of friction and the coefficients of abrasive wear rate. For this purpose, an authorial method using ball-cratering contact was used. The results were analyzed using statistical methods. It was found that the composite material using flax fibers does not differ significantly in its tribological properties from conventional solutions; so, it can be assumed that it can be used in the vehicle's braking system. [ABSTRACT FROM AUTHOR]