Power-saving effect and sensor characteristics of sandwich structure on oxygen sensors using hot spot.

A hot spot which is a glowing orange local area appears in RE Ba 2 Cu 3 O y (RE : rare earth) ceramic rods when a voltage higher than a certain value is applied at room temperature. After the hot spot appears, the oxygen partial pressure in the ambient atmosphere changes the current through the rod, which can be used as an oxygen sensor without the need for a heating system. In this study, the authors investigated the oxygen-sensing characteristics and the power-saving effect of the sandwich structure in which the sensor layer was stacked between insulation layers. The sample rods were prepared by the solid-state reaction at 960 °C. Materials of 5 mol% Nd 2 BaCuO 5 -added Nd 1.4 Ba 1.6 Cu 3 O y and 20 mol% Nd 1.4 Ba 1.6 Cu 3 O y -added Nd 2 BaCuO 5 were used for the sensor layer and the insulation layer, respectively. The sensitivity to the oxygen increased with increasing voltage applied to the rod. Under the condition where 17.8 V was applied to the rod with the sandwich structure and 6.6 V to the rod with the monolithic structure, the sensitivities of both rods were almost the same. The sandwich structure had a reduced current value and consumed approximately 26 % less power than the monolithic structure. The response time for the sandwich structure and the monolithic structure were comparable, meaning that the insulation layer did not impair the response time. [ABSTRACT FROM AUTHOR]