EVALUATION OF TENSILE AND COMPRESSION BENDING MOMENT OF L-TYPE JOINTS WITH 3D PRINTED CONNECTORS.

The paper investigates the bending moments under diagonal tensile and diagonal compression loads of L-type corner joints made of three wooden parts corresponding to the leg and the two stretchers used in chair construction. The wooden parts were jointed together with a 3D printed connector made of polylactic acid (PLA) filaments using Filament Fused Fabrication (FFF) as additive manufacturing technology. Larch (Larix decidua Mill.) wood was used to manufacture the wooden elements. In order to assess how the model orientation on the build platform influences the mechanical performance of the printed connector, two print positions were taken into account during the additive manufacturing (AM) process, namely horizontal and vertical. Mechanical testing under diagonal tensile and compression loads of the L-type corner joints, followed by the microscopic investigation of the fractured connectors with magnifications 50X, 80X, 100X were employed in this study. The results were compared with those of the reference L-type corner joint consisting of common mortise-tenon jointed wooden elements. The results show that the vertical orientation of the model on the build platform of the 3D printer is preferred for a better mechanical performance. The microscopy of the fractured connectors revealed the interlayer delamination of the filaments, especially in the case of the horizontal orientation of the model, which caused the wooden parts to slide out of the connector and record low values of the maximum failure loads. [ABSTRACT FROM AUTHOR]