Experimental research on the effects of the laser energy density on the morphology, phase, microstructure and properties of Q345D/20Mn2 dissimilar steel filler welding joints.

This study investigated the effects of laser energy density at different scanning speeds on the microstructure evolution, phase equilibrium, mechanical properties, and fracture modes of welds in dissimilar steel welded joints (Q345D and 20Mn2). The connection of dissimilar steel welded joints is achieved by using a laser synchronous powder feeding method. The microstructure and phase evolution of the joint were characterized by scanning electron microscopy (SEM) and X-ray diffraction (XRD). Mechanical property testing was performed on the joint via a micro-Vickers hardness tester and an electronic testing machine, and the fracture surface morphology was observed via a scanning electron microscope. The results show that when the laser energy density is 1125 J/mm2, the fine cellular crystals, columnar crystals, and equiaxed crystal structures of the joint are more uniformly distributed. As the laser energy density increased, the transition of the Q345D side structure from cellular to columnar crystals and the transition of the 20Mn2 side structure from cellular to equiaxed crystals became more pronounced. Mechanical property testing revealed that an increase in the laser energy density can significantly improve the microhardness and tensile strength of a joint. However, a large amount of the Fe matrix from the 20Mn2 side permeates into the coating, making the mechanical properties of the dilution zone lower than those of the crystallization zone, and making it more prone to fracture on this side. The fracture analysis results show that the fracture mode has strong ductility, and the fracture mode is judged to be ductile fracture. [ABSTRACT FROM AUTHOR]