Convective heat transfer and solid conversion of reacting particles in a copper(II) chloride fluidized bed

Abstract: This paper develops a predictive model of convective heat transfer and conversion of cupric chloride particles in a fluidized bed reactor of a copper–chlorine (Cu–Cl) cycle of thermochemical hydrogen production. The hydrolysis reaction of particles in the fluidized bed is endothermic and it requires excess steam for complete conversion of cupric chloride solid. The excess steam supply may be used for partial heat supply to the endothermic reaction, and also to avoid defluidization in the bed. To avoid defluidization, the change of gas flow in the bed due to the reaction should be minimized at a given operating condition. The model predicts the maximum possible steam inlet temperature, steam conversion, amount of partial heat supply, and also gas flow rates through the bed to avoid defluidization. The new model presents significant new insight by analyzing the hydrodynamic and mass transport processes, considering the equilibrium limitation on the conversion of cupric chloride solid. The model results indicate that the chemical reaction requires a high mole ratio of steam for complete conversion of cupric chloride particles. The maximum steam conversion is limited by temperature, pressure, and the presence of hydrogen chloride gas. The maximum conversion of steam at 400°C is 3.75% and it requires excess steam of 12.8 moles per unit mole of cupric chloride solid for complete conversion of solid. The heat supply by steam for the reaction, as well as raising the solid feed to the reaction temperature, varies with reaction temperature. The paper also adds significant new insight by analyzing the steam flow requirement in terms of temperature, conversion rate, and quality of fluidization. Additional new results are presented and applications discussed for the Cu–Cl cycle of nuclear hydrogen production. [ABSTRACT FROM AUTHOR]