A model study of tidal distributions in the Celtic and Irish Sea regions determined with finite volume and finite element models.

An unstructured mesh tidal model of the west coast of Britain, covering the Celtic Sea and Irish Sea is used to compare tidal distributions computed with finite element (FE) and finite volume (FV) models. Both models cover an identical region, use the same mesh, and have topography and tidal boundary forcing from a finite difference model that can reproduce the tides in the region. By this means, solutions from both models can be compared without any bias towards one model or another. Two-dimensional calculations show that for a given friction coefficient, there is more damping in the FV model than the FE model. As bottom friction coefficient is reduced, the two models show comparable changes in tidal distributions. In terms of mesh resolution, calculations show that for the M tide, the mesh is sufficiently fine to yield an accurate solution over the whole domain. However, in terms of higher harmonics of the tide, in particular the M component, its small-scale variability in near-shore regions which is comparable to the mesh of the model, suggests that the mesh resolution is insufficient in the near-coastal regions. Even with a finer mesh in these areas, without detailed bottom topography and a spatial varying friction depending on bed types and bed forms, which is not available, model skill would probably not be improved. In addition in the near-shore region, as shown in the literature, the solution is sensitive to the form of the wetting/drying algorithm used in the model. Calculations with a 3D version of the FV model show that for a given value of k, damping is reduced compared to the 2D version due to the differences in bed stress formulation, with the 3D model yielding an accurate tidal distribution over the region. [ABSTRACT FROM AUTHOR]