The distal metatarsal screw is not always necessary in third-generation MICA: a case-control study.

Introduction: To evaluate the clinical and radiological results after fixation of the first metatarsal head (MTH) with one or two screws as part of the third-generation minimally invasive Chevron-Akin osteotomy (MICA) for hallux valgus deformities.
Materials and Methods: Between August 2020 and November 2021, 55 MICA procedures (50 patients, male:female = 7:43), 22 with two (MICA2), 33 with one screw (MICA1) were performed for mild to severe hallux valgus deformities. Exclusion criteria were a concomitant pes adductus (Sgarlato angle > 20°) or hindfoot/midfoot deformities requiring treatment. In 27 cases, additional procedures on the forefoot (small toe corrections or metatarsal osteotomies II-V) were necessary. Pre- and post-operatively, hallux valgus angle (HVA) and intermetatarsal I/II angle (IMA) were measured. Clinically, subjective satisfaction, range of motion (ROM) of the first metatarsophalangeal joint (MTPJ), and pain level (NRS score) were evaluated. The minimum follow-up was 12 months.
Results: Displacement of MTH was 70-90% on average, all osteotomies showed full consolidation at latest follow-up. In one case of either group, a slight subsidence of MTH was documented. The radiological and clinical parameters showed no differences between the groups. The pain level improved by an average of three points. The mobility of the MTPJ showed a slight reduction in nine cases after three months (4 MICA2, 5 MICA1) which persisted in three cases. Fifty-two of 55 patients (95%) would opt again for the operation.
Conclusions: Fixation of the first MTH with a single bicortical screw in MICA with moderate lateralization of MTH shows stable anchoring and good clinical results. The routine use of a second metatarsal screw can be omitted.
(© 2022. The Author(s).)