Research on the Mechanical and Performance Effects of Flux on Solder Layer Interface Voids.

This article focuses on the study of voids in the solder joint interface of flip-chip LEDs. Additional flux is added to the solder paste to reduce the frequency of voids, and the mechanical properties of the solder joints are compared and analyzed. Two kinds of fluxes (NC559-TPF, TSF-6516) are selected. They are used in two kinds of solder pastes (lead and lead-free solder paste). The amount of flux added is 0 mL, 0.4 mL, and 0.8 mL. The other preparation conditions for all combinations are the same and are within the recommended scope of the manufacturer's documentation. X-rays are used to detect and analyze the distribution and quantity of voids in the solder layer. A push–pull tester is used to analyze and evaluate the mechanical strength of the solder joints. A scanning electron microscope was used to observe the microscopic morphology of the cross-section of the solder joint and the fracture morphology of the interface after the shear test. It was found that adding a proper amount of high-activity flux to the solder paste can reduce the frequency of voids and improve the mechanical reliability of the solder joints. Finally, we tested the thermal performance of the flip-chip LED filament for verification. [ABSTRACT FROM AUTHOR]