Characteristics of Pore Morphology in Aluminum Alloy Foams Fabricated by Semi-Solid Route among Multiple Experimental Runs.

A semi-solid route is expected to be a fabrication method that can fabricate aluminum alloy foams with a variety of mechanical properties, but the allowance fluctuation of the fabrication conditions of aluminum alloy foams with high reproducibility is not clear. The objective of this study was to reveal the allowance fluctuation between the setting temperature and the actual temperature of the melt to fabricate stable foams, having pores with small pores and high circularity, and the influence of the increasing volume fraction of the solid on the pore morphology. Al-Si alloy foams were fabricated five times by adding a blowing agent into a semi-solid slurry under the same setting fabrication conditions, such as the temperature and concentration of oxygen in the atmosphere. The results of small relative standard deviations of pore diameter and circularity indicated that the conducted fabrication process had high reproducibility, even if the volume fraction of the solid changed in a range of 5%. When the volume fraction of the solid exceeds the minimal fraction of primary crystals for prevention of drainage, the clogging effect works more efficiently because the ratio of clogged cell walls increases. Additionally, the preferred range of the volume fraction of the solid for the fabrication of stable foam was revealed to be around 15% to 35%. [ABSTRACT FROM AUTHOR]