Influence of Liner Surface with Parameterized Pit Texture on the Friction Characteristics of Piston Rings.

The arrangement of a pit-shaped surface texture on the surface of a cylinder liner significantly affects reductions in piston ring friction, and the influence of the structural parameters and spatial distribution on piston ring friction power consumption is unclear. In this paper, the diameter, depth, axial spacing distance, and radial spacing distance of the pits on the inner surface of a cylinder liner were used as variable parameters to process the surface textures of different schemes, and then a friction and wear test was carried out on UMT piston ring–cylinder liner specimens, several texture schemes with the best anti-friction effect were selected, an engine bench test was carried out by comparing these texture schemes with non-texture schemes, and the frictional torque and fuel consumption of the engine were studied at different oil temperatures. The results show that the depth of the pits in the surface texture of a cylinder liner has a greater influence on the friction reduction effect, followed by the radius. The higher the oil temperature in the engine bench test, the greater the impact of the surface texture. The reduction in fuel consumption was greater in the lower-speed region after structuring the textured cylinder liner compared to the non-textured cylinder liner. Specifically, the friction coefficient was mainly affected by the depth of the pits, and the depths of the pits in the texture schemes with good friction reduction effect were all 17–19 μm. The best friction reduction could be achieved when the pit radius is around 50 μm, with little difference in pit depth. When the oil temperature was 95 °C, the average drag torque reduction was about 1.69 Nm; when the oil temperature was 105 °C, the decrease was about 2.54 Nm; and when the oil temperature was 105 °C, the decrease was about 4.53 Nm. After adding the surface texture of the cylinder liner, the fuel consumption rate of the engine equipped with the structured cylinder liner was generally reduced compared with that of the original cylinder liner engine. Among them, the average and subsequent consumption rate of surface assembly scheme 11 decreased the most, with a value of 1.3 g/kwh. [ABSTRACT FROM AUTHOR]