Performance of Transition Metal Supported Al2O3 Coated on Honeycomb Catalysts and Its Segmentation on Exhaust Gasses Oxidation.

The oxidation of carbon monoxide (CO) and unburnt hydrocarbons (HC) under segmented honeycomb catalysts was investigated using actual exhaust gas mixtures from a gasolinefueled internal combustion engine of a motorcycle. The honeycomb catalysts were prepared through a wet process, resulting in four types coated with transition metals (Cu, Cr, Fe, and Ni) supported on Al₂O₃. The oxidation of CO and HC was monitored using an exhaust gas analyzer across a range of air-to-fuel ratios (AFR), from lean to rich, under stationary conditions. The results demonstrate that the honeycomb catalysts effectively decreased CO and HC concentrations in the exhaust gas. Among the transition metal oxide honeycomb catalysts, Cr and Ni exhibited high CO and HC conversion rates, surpassing those observed with Cu. The average CO and HC conversion calculations, spanning from lean to rich air-tofuel ratios, were consistent with the actual conversion rates achieved. Furthermore, the study investigated the effect of honeycomb segmentation on CO and HC conversion. Surprisingly, the catalytic performance of Cr and Ni remained high even with longer gaps in the honeycomb. Interestingly, the conversion of CO and HC over the iron oxide honeycomb catalyst increased as the gap in the honeycomb became longer. This is likely due to an increase in the gap size and enhanced re-mixing of reactants (CO, HC, and O2) caused by recirculation. Thus, this study provides valuable elucidation on the potential application of segmented honeycomb catalysts for reducing CO and HC emissions in exhaust gases. [ABSTRACT FROM AUTHOR]