Changes in 3-Dimensional Measurements of Masseter Muscle After Orthognathic Surgery in Patients with Facial Asymmetry.

Objective: The aim of this study was to quantitatively evaluate morphological and volumetric changes in the masseter muscle using 3-dimensional analysis of facial asymmetry patients and to identify factors influencing these changes before and after orthognathic surgery. Methods: [Reviewer1 (2)]A single-center retrospective cohort study was conducted on twenty-two patients with deviation of the chin > 4 mm. Masseter muscle volume and morphology were measured at different periods during long-term follow-up (mean 15 ± 3.2 months). Factors related to changes in masseter muscle cross-sectional area and volume analyzed were also analyzed. Results: [Reviewer1 (2) and (9)]The volume and cross-sectional area of the masseter muscle on the non-deviated side reduced by 13.5% (P < 0.05) and 16.4% (P < 0.05), respectively, after orthognathic surgery. The length of the masseter muscle increased by 13.9% on the deviated side (P <.05) but decreased by 11.7% on the non-deviated side (P < 0.05). The width decreased on the deviated side from T1 to T2 (13.51 ± 2.09 mm vs. 12.04 ± 1.39 mm), but the non-deviated side showed an opposite tendency (10.81 ± 1.31 mm vs. 12.69 ± 2.37 mm). The difference in masseter muscle length and width between the two sides significantly reduced after surgery (P < 0.05). There was a noticeable decrease in the asymmetry in the muscle in proportion to the degree of the occlusal plane angle. Conclusion: Masseter muscle asymmetry exists in patients with facial asymmetry, but it could be improved with maxilla-mandible correction. Atrophy of the masseter muscle after orthognathic surgery was greater in patients with a large inclined occlusal plane angle due to improved dental compensation. Level of Evidence IV: This journal requires that authors assign a level of evidence to each article. For a full description of these Evidence-Based Medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266. [ABSTRACT FROM AUTHOR]