Preparation of Heat and Salt Resistant Foam Composite System Based on Weathered Coal Particle Strengthening and a Study on Foam Stabilization Mechanism.

Nitrogen foam is a promising enhanced oil recovery (EOR) technique with significant potential for tertiary oil recovery. This improves the efficiency of the oil displacement during the gas drive processes while expanding the swept volume. However, in the high-temperature, high-salinity reservoirs of the Tahe Oilfield, conventional N₂ foam systems show suboptimal performance, as their effectiveness is heavily limited by temperature and salinity. Consequently, enhancing the foam stability under these harsh conditions is crucial for unlocking new opportunities for the development of Tahe fracture-vuggy reservoirs. In this study, the Waring–Blender method was used to prepare weathered coal particles as a foam stabilizer. Compared to conventional foam stabilizers, weathered coal particles were found to enhance the stability of the liquid film under high-temperature and high-salinity conditions. Firstly, the foaming properties of the six foaming agents were comprehensively evaluated and their foaming properties were observed at different concentrations. YL-3J with a mass concentration of 0.7% was selected. The foaming stabilization performance of four types of solid particles was evaluated and weathered coal solid particles with a mass concentration of 15% and particle size of 300 mesh were selected. Therefore, the particle-reinforced foam system was determined to consist of "foaming agent YL-3J (0.7%) + weathered coal (15.0%) + nitrogen". This system exhibited a foaming volume of 310 mL at 150 °C and salinity of 210,000 mg/L, with a half-life of 1920 s. Finally, through interfacial tension and viscoelastic modulus tests, the synergistic mechanism between weathered coal particles and surfactants was demonstrated. The incorporation of weathered coal particles reduced the interfacial tension of the system. The formation of a skeleton at the foam interface increased the apparent viscosity and viscoelastic modulus, reduced the liquid drainage rate from the foam, and mitigated the disproportionation effect. These effects enhanced the temperature, salinity resistance, and stability of the foam. Consequently, they contributed to the stable flow of foam under high-temperature and high-salinity conditions in the reservoir, thereby improving the oil displacement efficiency of the system. [ABSTRACT FROM AUTHOR]