Detect-and-Activate-the-Heater Protection Technique for YBCO Coils.

This paper presents the results of work, experimental and simulation, performed on an YBCO pancake coil to develop a detect-and-activate-the-heater (DAH) protection technique. In this DAH protection technique a "protection heater" (PH) is activated, upon the detection of a quench zone in a coil, to create an additional normal zone to absorb the stored magnetic energy sufficient to keep the initially quenched zone (hot spot) from overheating. It is computed that a protection heater for most coils needs to cover only a fraction of the winding to keep the quenched zone from overheating. The pancake coil used in the experiment, 100-mm i.d., 190-mm 04., and 4.3-mm height, is dry-wound with copper plated YBCO tape, 4.3-mm wide, 96.3-μm thick, 100-m long, and is turn-to-turn insulated with 38-μm thick Nomex spacer. The pancake stores a magnetic energy of 30 J at an operating current of 80 A at 65 K. Because the smaller the magnet size, the less applicable the assumption of adiabatic conditions is and also the more beneficial NZP becomes that would otherwise be negligible in "large" magnets, the hot spot temperature observed in the experiment with this "small" test coil was much less than that computed based on the assumptions of adiabatic conditions and no NZP. To validate the basic concept and consequences of DAH protection technique either a test coil has to be large or if the same coil is to be used, it should be tested at the temperature range close to 20-30 K so that the coil can carry a large current and thus store a large magnetic energy. [ABSTRACT FROM AUTHOR]