Effect of the increase in the entrance convergent section length of the gun nozzle on the high-velocity oxygen fuel and cold spray process.

Nozzle geometry, which influences combustion gas dynamics and, therefore, sprayed particle behavior, is one of the most important parameters in the high-velocity oxygen-fuel (HVOF) thermal spray process. The nozzle geometry is also important in the cold spray method. The gas flows in the entrance convergent section of the nozzle exhibit a relatively higher temperature and are subsonic; thus, this region is most suitable for heating spray particles. In this study, numerical simulation and experiments investigated the effect of the entrance geometry of the gun nozzle on the HVOF process. The process changes inside the nozzle, as obtained by numerical simulation studies, were related to the coating properties. An Al₂O₃-40 mass% TiO₂ powder was used for the experimental studies. The change in entrance convergent section length (rather than barrel part length or total length) of the gun nozzle had a significant effect on the deposition efficiency, microstructure, and hardness. The deposition efficiency and hardness increased as this geometry increased. On the other hand, the calculated and measured particle velocity showed a slight decrease. This effect on the HVOF process will also be applied to the nozzle design for the cold spray method. [ABSTRACT FROM AUTHOR]