Model NbTi Helical Solenoid Fabrication and Test Results.

Authors :: Andreev, N.
Barzi, E.
Chlachidze, G.
Evbota, D.
Kashikhin, V. S.
Kashikhin, V. V.
Lamm, M. J.
Makarov, A.
Novitski, I.
Orris, D. F.
Tartaglia, M. A.
Tompkins, J. C.
Turrioni, D.
Walbridge, D.
Yu, M.
Zlobin, A. V.
Source :: IEEE Transactions on Applied Superconductivity; Jun2012, Vol. 22 Issue 3, p4101304-4101304, 4p
Publication Year :: 2012
Abstract: A program to develop model magnets for a helical cooling channel is under way at Fermilab. In the first steps of a planned sequence of magnets, two four-coil helical solenoid models with 300 mm aperture have been fabricated and tested. These two models, HSM01 and HSM02, used insulated NbTi Rutherford cable wound onto stainless steel rings with spliceless transitions between coils. Strip heaters were included for quench protection of each coil, and the coils were epoxy-impregnated after winding inside the support structures. Based on the results of the first model the second model was made using a cable with optimized cross-section, improved winding and epoxy-impregnation procedures, enhanced ground insulation, and included heat exchange tubing for a test of conduction cooling. We report on the results and lessons learned from fabrication and tests of these two models. [ABSTRACT FROM PUBLISHER]