Fatigue and fracture behavior of laser clad repair of AerMet® 100 ultra-high strength steel

The effect of laser cladding on the fatigue and fracture behavior under variable amplitude loading is a major consideration for the development of laser cladding process to repair high value complex fatigue critical aerospace military components, that otherwise would be replaced. The selected material, AerMet®100, is a widely used ultra-high strength steel in current and next generation aerospace components, such as landing gears. Laser cladding was performed using AerMet® 100 powder on AerMet® 100 fatigue substrate specimens. No micro-cracking and very little porosity were observed in the clad layer. The fatigue tests were performed under variable amplitude loading with a maximum stress of 1000 MPa. Residual stress, microstructure, and hardness, was also evaluated. Both the as-clad and post-heat treated (PHT) samples were compared to a baseline sample with an artificial notch to simulate damaged condition. Results show that laser cladding significantly improves fatigue life, as compared to the baseline sample with a notch. However, the fatigue life of the as-clad sample is lower as compared to a baseline sample without a notch. A compressive residual stress of 300–500 MPa was observed in the clad region and HAZ. The fracture modes in the as-clad specimen consisted mainly of tearing topology surface and some regions of decohesive rupture through the columnar austenite grains. The PHT condition however was not effective in improving the fatigue life. The fracture modes showed mainly decohesive rupture, and as a consequence, reduced the fatigue life.