The development of molecular orientation and morphological texture in thermotropic copolyesters

Liquid crystalline polymers can be processed to form high strength/modulus materials. In processing these materials, it is apparent that molecular orientation is an important factor in determining the physical strength of the processed materials. In this study a systematic investigation was carried out to determine how a thermotropic copolyester of parahydroxybenzoic acid (PHB) and polyethylene terephthalate (PET) responds to two basic types of flows: shear and extensional flow. This was accomplished by preparing sheared and extended samples under controlled conditions of temperature and flow history. Sheared disks were prepared using a disk and plate geometry of a Rheometrics Mechanical Spectrometer (RMS model 605), while extended ribbons were prepared using a slit die attached to an Instron capillary rheometer. Two copolymerer compositions of 60 mole percent and 80 mol percent PHB were investigated. The sheared disks and extended ribbons were investigated for molecular orientation and morphological textures using wide angle x-ray scattering (WAXS) and scanning electron microscopy (SEM) analysis, respectively. It was found that extensional flow has a greater capacity for orienting such materials than shear flow. Samples annealed at their softening points for 1 minute (240°C for the 60 mole percent PHB/PET copolymer and 300°C for the 80 mole percent PHB/PET copolymer) showed no significant loss of orientation, indicating that once orientation is produced it may remain in the melt for a long period of time. Sheared samples prepared by shearing the sample while cooling showed significantly higher degrees of orientation than those not cooled while being sheared. This may indicate that a minimum stress level exists for the production of orientation in shear flow.