Effect of zirconia and aluminium titanate on the mechanical properties of transformation-induced plasticity-matrix composite materials

Metal-matrix composite materials composed of an austenitic stainless steel with different ceramic particle reinforcements were investigated in this study. The test specimens were prepared via a powder metallurgical processing route with extrusion at room temperature. As reinforcement phase, either magnesia partially stabilized zirconia or aluminium titanate with a volume content of 5% or 10% was used. The mechanical properties were determined by quasi-static compressive and tensile loading tests at ambient temperature. The microstructure characteristics and failure mechanisms during deformation contributing to significant changes in strength and ductility were characterized by scanning electron microscopy including energy dispersive X-ray spectroscopy and electron back-scatter diffraction, and by X-ray diffraction. The composite materials showed higher stress over a wide range of strain. Essentially, the deformation-induced formation of α′-martensite in the steel matrices is responsible for the pronounced strain hardening. At higher degrees of deformation, the material behavior of the composites was controlled by arising damage evolution initiated by particle/matrix interface debonding and particle fracture. The particle reinforcement effects of zirconia and aluminium titanate were mainly controlled by their influences on martensitic phase transformations and the metal/ceramic interfacial reactions, respectively. Thereby, the intergranular bonding strength and the toughness of the steel/ceramic interfaces were apparently higher in composite variants with aluminium titanate than in composites with magnesia partially stabilized zirconia particles.