Diagnosis and Ablation of Atrial Flutter Using a High Resolution, Noncontact Mapping System

The ablation of atrial flutter can sometimes be time consuming and unsuccessful using conventional catheter techniques especially in patients with recurrences after previous ablation procedures. Simultaneous high resolution mapping from multiple sites may overcome some of the limitations. Therefore, a new high resolution noncontact mapping system was used for diagnosis and ablation of atrial flutter in 15 patients. The mapping system consists of a catheter-mounted multielectrode array, an amplifier, and a computer workstation. Far-field potentials recorded by the multielectrode catheter are amplified, digitized, and sampled at 1.2 kHz, and digitally filtered to construct high resolution activation maps during tachycardia. Ablation catheters can be steered to target sites without fluoroscopy. In 12 of the 15 patients the analysis of the activation sequence during tachycardia showed a counter-clockwise, and in 1 of 15 patients a clockwise, rotating wavefront using the isthmus as part of the reentrant circuit. In two patients no tachycardia could be induced. In 3 of the 15 patients with previous conventional ablation procedures the gap in the line of block in the isthmus region was identified and marked on the animation model. The isthmus in the right atrium was ablated and isthmus block verified by the mapping system in all patients. No complications were observed. No recurrences of atrial flutter occurred during follow-up of 4 +/- 1.7 months. The total procedure and fluoroscopy time was 171 +/- 50.0 minutes and 24 +/- 12.7 minutes, respectively. In conclusion, the use of the new high resolution noncontact mapping system in patients with right atrial flutter is safe and highly effective. In patients with previously failed conventional ablation procedures the use of a noncontact mapping system may facilitate the identification of the gap in the line of block in the isthmus region and reablation of atrial flutter.