Experimental investigation of the influence of wool structures on the stab resistance of woven body armor panels

International audience; In the production of body armor panels, multilayer aramid fabrics are normally used. A main problem of these panels is the high weight and consequential lower comfort for the wearer. In a recent survey it was shown that most officers in the United States would prefer an improved comfort and also reduced weight in their ballistic vests. To reduce layers with a concomitance of the same safety standards, the panel has to be improved. One solution is to reduce the slippage of the yarns during the penetration of the knife and with this to increase the absorbed impact energy. The tests showed that the placement of a layer of wool fabric on the top of the aramid panel changes the penetration behavior. The main goal of this work is the investigation of the influence of the woven wool structure over the penetration of aramid panels. For this investigation, the stab resistance of five aramid fabrics with different properties and patterns combined with one layer of wool on the top and bottom of the panel has been tested and compared against pure aramid panels, according to the VPAM test instruction “Stab- and Impact Protection”. In addition, an optical evaluation of the stab tests has been done using a high-speed camera. Also, the stab recess in the aramid layers was evaluated optically, using a digital microscope. The experimental results confirm that wool can increase the stab resistance of body armor panels, but results are dependent on the properties and pattern of the aramid fabrics, too.