Development of High-Resolution Soil Hydraulic Parameters with Use of Earth Observations for Enhancing Root Zone Soil Moisture Product

Regional quantification of energy and water balance fluxes depends inevitably on the estimation of surface and rootzone soil moisture. The simulation of soil moisture depends on the soil retention characteristics, which are difficult to estimate at a regional scale. Thus, the present study proposes a new method to estimate high-resolution Soil Hydraulic Parameters (SHPs) which in turn help to provide high-resolution (spatial and temporal) rootzone soil moisture (RZSM) products. The study is divided into three phases—(I) involves the estimation of finer surface soil moisture (1 km) from the coarse resolution satellite soil moisture. The algorithm utilizes MODIS 1 km Land Surface Temperature (LST) and 1 km Normalized difference vegetation Index (NDVI) for downscaling 25 km C-band derived soil moisture from AMSR-2 to 1 km surface soil moisture product. At one of the test sites, soil moisture is continuously monitored at 5, 20, and 50 cm depth, while at 44 test sites data were collected randomly for validation. The temporal and spatial correlation for the downscaled product was 70% and 83%, respectively. (II) In the second phase, downscaled soil moisture product is utilized to inversely estimate the SHPs for the van Genuchten model (1980) at 1 km resolution. The numerical experiments were conducted to understand the impact of homogeneous SHPs as compared to the three-layered parameterization of the soil profile. It was seen that the SHPs estimated using the downscaled soil moisture (I-d experiment) performed with similar efficiency as compared to SHPs estimated from the in-situ soil moisture data (I-b experiment) in simulating the soil moisture. The normalized root mean square error (nRMSE) for the two treatments was 0.37 and 0.34, respectively. It was also noted that nRMSE for the treatment with the utilization of default SHPs (I-a) and AMSR-2 soil moisture (I-c) were found to be 0.50 and 0.43, respectively. (III) Finally, the derived SHPs were used to simulate both surface soil moisture and RZSM. The final product, RZSM which is the daily 1 km product also showed a nearly 80% correlation at the test site. The estimated SHPs are seen to improve the mean NSE from 0.10 (I-a experiment) to 0.50 (I-d experiment) for the surface soil moisture simulation. The mean nRMSE for the same was found to improve from 0.50 to 0.31.