Use of 1D mechanical and thermal models to predetermine the heat transferable by a thermal interface material layer in space applications

International audience; This paper proposes the use of 1D basic models to build a design assistance tool capable of evaluating the heat transfer between a third-level electronic packaging and its support, considering a conventional configuration where a thermal interface material is placed between these two parts. Using this kind of tool early in the design process may facilitate choices concerning geometry and material. The packaging is modelled by a stepped beam (the equipment) and the interface layer by a nonlinear elastic foundation (the thermal interface material). Considering that the electronic equipment bends under the effect of the forces exerted by the fasteners, the tool makes it possible to determine the contact zone remaining operative after deformation, and the pressure distribution at the interface. Mechanical results are then used to calculate the steady-state heat transfer between the equipment and its support, taking into account the diffusion within the equipment and the thermal interface material, and also the thermal contact resistances, the latter being dependent on the contact pressure. A detailed case study is used to illustrate the utility of the approach. The 1D models are exploited to illustrate the interest of the design assistance tool. The influence of different parameters on the thermal performance is studied and a new innovative proposal is analyzed, which could lead to a significant increase in thermal performance.