Modelling and design guidelines of integrated high-temperature photoelectro-chemical devices

[EN] In the present study, hydrogen and syngas fuels are delivered from water electrolysis and coelectrolysis of water and carbon dioxide, respectively, though the use of an integrated hightemperature photoelectrochemical device, composed of a high temperature solar cell (HTSC) coupled with a solid oxide electrolyser (SOE). Clean, renewable and available solar energy is used as the power source of this device. A numerical multiphysics model is developed, including a one-dimensional model designed to represent the high temperature photoabsorber assembly, and a two-dimensional model embodying the solid oxide electrolyser. The performance of this integrated device is assessed according to certain parameters, including the molar flow of fuel produced at the outlet of the device and the solar-to-fuel efficiency. The productivity of the device is analysed for both fuel production simulations under a variety of different scenarios, where parameters affecting the structure’s design, the material properties and the operating and boundary conditions are varied. The resulting energetic and production performances under each case scenario are measured and appraised, in order to get a broader insight in the effect of these variables in the performance of the fuel-producing device and provide general device design guidelines. The acquired results show the difference in importance of some specifications over others in the performance of the device. The parametric study for the hydrogen production reveals the number of photoabsorbers as the parameter which most significantly affects the performance of the device. In order to maximise the performance of the HTSC-SOE integrated device, addressing this parameter, a simulation is carried out which allowed to determine the optimum combination of parameters that the device should possess in order to obtain the maximum solar-to-fuel efficiency possible and deliver the highest amount of hydrogen molar flow rate. On the other hand, the para
[ES] En este proyecto se diseña un dispositivo integrado para la producción de hidrógeno en el que la electrólisis de agua para producirlo se alimenta de la corriente producida por un panel solar (que usa energía solar). La eficiencia se estudia variando ciertos parámetros de diseño, como puede ser la velocidad de entrada de las especies en las cámaras del ánodo y cátodo, a través de un estudio paramétrico, con el fin de poder definir parámetros generales de diseño. Los programas utilizados son: MATLAB (para modelar el panel solar) y COMSOL (para modelar el electrolizador).