Search

For nanosecond pulsed gas discharge under hundreds of kV/cm in sulfur hexafluoride (SF6), the electric field emission (EFE) effect may be the mechanism of the initial electrons. Electrode surface micro-protrusions (ESMPs) generated after discharging, would affect the discharge process under a high electric field. To investigate the effect of ESMPs on the breakdown time delay and jitter, the breakdown characteristics of different electrode materials and surface roughness are determined in this paper. Three types of electrode materials include stainless 304L, EDM-AF5 graphite, and CuW70 W-Cu alloy. The influences of stainless 304L electrodes with surface roughness coefficients of 1.6 and 0.8 on the breakdown delay and jitter are compared. After 700 discharge shots, the morphology characteristics and distributions of ESMPs are observed by a contourgraph. Based on the statistical results of ESMPs and EFE theory, the relationship between the electric field of EFE and ESMPs can be calculated. In addition, the effective electron rates of negative ion detachment (NID) are estimated. The experimental and calculation results indicate that the initial electrons are mainly produced by the EFE effect. When the pressure is below 0.5 MPa, the NID effect is limited and the breakdown time delay and jitter are dependent on the height to radius ratio and distributions of ESMPs. Once the pressure exceeds 0.5 MPa, the NID effect will be significant and the influence of ESMPs can be neglected. [ABSTRACT FROM AUTHOR]

Surface evolution for a conductor electrode under pulsed megagauss (MG) magnetic field was investigated. Stainless steel rods with 3 mm diameter were driven by 8 MA, 130 ns (10%–90%) current pulse in a series of shots on the Primary Test Stand. Experimental data from two complementary diagnostic systems and simulation results from one-dimensional magneto-hydrodynamics code reveal a transition phase for instability development. The transition, which begins as the conductor surface starts to expand, lasts about 40 ns in the pulse. It ends after the thermal plasma is formed, and striation electrothermal instability growth stops but magneto-Rayleigh-Taylor instability (MRTI) starts to develop. An expanding velocity which grows to about 2.0 km/s during the transition phase was directly measured for the first time. The threshold magnetic field for thermal plasma formation on the stainless steel surface was inferred to be 3.3 MG under a rising rate of about 66 MG/μs, and after that MRTI becomes predominant for amplitude growth in surface perturbation. [ABSTRACT FROM AUTHOR]