Search

This article compares the characteristics of a dual three-phase synchronous motor under different operating conditions such as healthy, half-control, and postfault conditions. The inductances are analyzed to confirm the interaction between two three-phase systems, and induced voltages of each phase are measured to verify the interaction behaviors. The postfault characteristics are analyzed under open-circuit faults (single-open-switch and single-open-phase faults) and short-circuit faults (single-short-switch and one-three-phase-short faults). The predicted results are validated by experimental tests. Moreover, the half-control mode is investigated as a strategy to operate with high efficiency and tolerant mode. [ABSTRACT FROM AUTHOR]

This study presents two design methodologies for high-speed synchronous reluctance (REL) machines. The interest for high-speed drives comes from the request for compactness and high efficiency. The synchronous REL motors have been widely studied for several applications, but a coherent design procedure for high speed has not been proposed in the literature. The study proposes some analytical procedures to get an initial design. Then the rotor geometry optimisation through a differential evolution algorithm is described. Finally, a design example is given and thoroughly analysed using these two approaches. [ABSTRACT FROM AUTHOR]

The synchronous reluctance machines with transversally laminated rotor and multi flux barriers per pole reach a high torque density, so that they are proposed as a valid alternative to permanent magnet machines. Such machines have been analyzed for different applications, mainly home appliance, industrial tool, traction, up to low-speed high-power generators. On the contrary, the use of synchronous reluctance machines for high-speed applications remains almost unexplored yet. The aim of this paper is to investigate the potential of a high-speed synchronous reluctance machine. An optimization is carried out so as to maximize the machine performance (high power, proper power factor, low vibration) at a given speed. The machine size is fixed and the focus is on the rotor geometry, with the purpose of maximizing the electromagnetic torque, according to the necessary thickness of the ribs. It is shown that, even if the ribs are thick, it is possible to reach a proper torque density. It is shown that different solutions exist, which allow to reach high torque and minimum torque ripple. However, the optimal solutions are quite sensitive to the geometrical variations, so that a particular care is required in the manufacturing of the machine. Finally, the power limit of the synchronous reluctance motor with barrier rotor is found. [ABSTRACT FROM AUTHOR]

This study presents two design methodologies for high‐speed synchronous reluctance (REL) machines. The interest for high‐speed drives comes from the request for compactness and high efficiency. The synchronous REL motors have been widely studied for several applications, but a coherent design procedure for high speed has not been proposed in the literature. The study proposes some analytical procedures to get an initial design. Then the rotor geometry optimisation through a differential evolution algorithm is described. Finally, a design example is given and thoroughly analysed using these two approaches. [ABSTRACT FROM AUTHOR]