Search

Anatase TiO 2 ultra-thin nanosheets (TiO 2 -NS) are synthesized by a facile hydrothermal method. Several merits are realized when employing the prepared TiO 2 -NS as lithium ion battery anode material, compared to TiO 2 nanoparticles. Firstly, the as-prepared TiO 2 -NS has high charge capacities and a specific surface area up to 98.8 m 2 g −1 , which is beneficial for the insertion of lithium ion. Secondly, the large specific surface area is helpful in enlarging the electrode/electrolyte interfacial area. Finally, the EIS result verifies short electron transfer paths. More importantly, the stability of the nanosheet structure is indirectly confirmed by the excellent cycling performance of charge capacity and the curve of charge capacities versus cycle number at different current densities. After galvanostatic charge/discharge of the batteries for 1000 cycles, the HRTEM images of post-mortem batteries directly reveal a good reversibility of the lithium ion insertion/extraction process aided by TiO 2 -NS. Thus, all these advantages and the special structure facilitate an excellent cycling performance: the charge capacity with the maximum value of 250 mAh g −1 keeps half after 2000 cycles at a current density of 840 mA g −1 (5 C). [ABSTRACT FROM AUTHOR]

We demonstrate a method for incorporating plasmon metallic nanoparticles in hierarchical rutile TiO 2 clusters (RTC) assembled from single-crystal nanospindles. The RTC could efficiently improve the diffusion of the photoelectrons, which can be ascribed to the improvement of the connectivity by bridging the neighbouring microflowers through the single-crystal nanospindles. But not all the nanospindles are tightly interconnected, hence organic colloid has been prepared for post-treatment of the device based on RTC by the generation of TiO 2 nanoparticles. When added into Au nanoparticles, localized electric fields can be produced, because Au can excite dye molecules more intensively than incident far-field light. The surface plasmon synergistic effect had been investigated by Uv-vis absorption spectrum of Au@ organic colloid and the relative change of the IPCE. As a result, the cell based on RTC exhibits an overall conversion efficiency of 7.68%, indicating a 17% promotion compared with that derived from commercial P25 (6.58%) which could be ascribed to faster electron transfer of single-crystal nanospindles. With the Au nanoparticles incorporation in RTC, the device achieves a conversion efficiency of 9.15%, resulting in a 11% increase compared to the RTC device post-treated by organic colloid without Au nanoparticles (8.24%), which is attributed to the surface plasmon synergistic of Au nanoparticles. [ABSTRACT FROM AUTHOR]

Abstract: Light harvesting in dye-sensitized solar cells (DSSCs) mediated by plasmonic metallic nanoparticles and sub-micron light-scattering metal oxides is a facile and cost-effective approach to achieving high device performance. Ag nanoparticles, protected by thin shells of TiO2, were incorporated in TiO2 photoanode. The large plasmonic near-field intensity generated by these nanoparticles caused an 18.3% rise in photocurrent, which resulted in an enhanced efficiency of 6.23% as compared to 5.29% efficiency of DSSC based on unmodified TiO2 photoanode. In addition, DSSC with TiO2 nanofibers (NFs) embedded in TiO2 photoanode was also constructed, which because of the efficient light scattering ability of the nanofibers, attained an efficiency of 7.14% as a result of a current rise of 36.9%. Another DSSC was assembled with Ag NPs added to the photoanode of the NFs-based DSSC to further boost cell performance. The addition of Ag NPs, however, did not produce an appreciable change in the cell performance. The reason for this unexpected outcome was probably due to the low internal resistance associated with charge recombination and large resistance to electron transport in the cell as determined by electrochemical impedance analysis computed in this work. [Copyright &y& Elsevier]

Abstract: TiO2 doping has been widely used to improve the performance of dye-sensitized solar cells. In this paper, we study the use of N as a dopant of TiO2 in dye-sensitized solar cells (DSSCs), analyzing the effect on the photovoltaic properties of the cells based on different amounts of N doping. Results indicate that the dye absorption is increased, which would enhance the amount of photoelectron; moreover, the resistance (R 3) of the electron transport within photoelectrode and electron lifetime of it are improved by N doping. The above two reasons would lead the high short circuit current density (J sc). However, owing to the sites of recombination and severe defects introduced, the trend of dye absorption, R 3 and electron lifetime is opposite when the amount of N doping is more than 3%. Finally, we find that the optimal amount of N doing is 3%, which outstandingly increase the performance of DSSCs. The conversion efficiency of the DSSCs can be reached to 6.25% when using the 3% N-doped TiO2 photoelectrode, and this efficiency is 23.03% higher than that of the pure TiO2. [Copyright &y& Elsevier]