Search

Active rectifiers interfacing the grid have gained much attention in recent years due to their current control capability that enables the application to exchange a certain range of power at the benefit of low harmonic distortion compared to line commutated converters. Moreover, the amount of active and reactive powers can be arbitrarily chosen within certain limits. These limits as well as the degree of harmonic attenuation is determined by the line-side filter. This paper basically focuses on the current control of active rectifiers incorporating a line-side filter of first-up to third-order degree. Thus, it treats both the current-source converter (CSC) as well as the voltage-source converter (VSC). The basic models of the plant are derived for each case, and important dualities are pointed out. As a conclusion, a recipe for the controller design of particularly CSCs with LC filters and VSCs with LCL filters is proposed. Index Terms--AC-DC power conversion, current control, pulsewidth modulation (PWM), voltage control.

Voltage--oriented PI control of three-phase grid-connected pulsewidth-modulation rectifiers with LCL filters is addressed. LCL filters require resonance damping. Active resonance damping is state of the art to face the problem, but it is still under investigation because of the manifold solutions. It is often realized using many sensors and/or complex control algorithms. In contrast, pure PI control requires only one set of current sensors, and its implementation and design are rather simple and well known from the L filter control. PI control has already been shown to be a suitable solution also for LCL filters, but there are limitations. These are investigated in this paper. System stability is analyzed with respect to different ratios of LCL filter resonance and control frequencies. The latter are important parameters for system design and control. Both line and converter current control are analyzed. For a certain range of frequency ratios, the voltage-oriented PI control gives stable performance without additional feedback, but for ratios outside this range, stable operation is impossible. Experimental tests validate the theoretical results. In addition, an experimentally determined LCL filter transfer function is shown in this paper, which shows a lower resonance peak as expected from commonly used filter models. Index Terms--Active damping (AD), grid-connected pulsewidth-modulation (PWM) rectifier, LCL filter, PI current control.

Pulsewidth modulation (PWM) voltage source converters are becoming a popular interface to the power grid for many applications. Hence, issues related to the reduction of PWM harmonics injection in the power grid are becoming more relevant. The use of high-order filters like LCL filters is a standard solution to provide the proper attenuation of PWM carrier and sideband voltage harmonics. However, those grid filters introduce potentially unstable dynamics that should be properly damped either passively or actively. The second solution suffers from control and system complexity (a high number of sensors and a high-order controller), even if it is more attractive due to the absence of losses in the damping resistors and due to its flexibility. An interesting and straightforward active damping solution consists in plugging in, in cascade to the main controller, a filter that should damp the unstable dynamics. No more sensors are needed, but there are open issues such as preserving the bandwidth, robustness, and limited complexity. This paper provides a systematic approach to the design of filter-based active damping methods. The tuning procedures, performance, robustness, and limitations of the different solutions are discussed with theoretical analysis, selected simulation, and experimental results. [ABSTRACT FROM PUBLISHER]

Inverter systems that feed electrical power from fuel cells into the grid must convert the direct current of the fuel cell into the alternating current of the grid. In addition, these inverters have to adapt the different voltages of the fuel-cell system and the grid to each other. In this paper, different topologies of appropriate inverter systems in the medium power range of 20 kW and higher are presented briefly. The inverter operating behavior, power rating, and efficiency are compared. The power rating and efficiency are compared using an analytical calculation of the semiconductor losses. The study includes transformerless inverters as well as two-stage inverter systems with high-frequency transformers (dc/dc converter combined with an inverter). This paper compares converter systems using insulated-gate bipolar transistors (IGBTs), e.g., a boost converter in series with a voltage-source inverter (VSI), current-source inverter, and z-source inverter or converter systems using superjunction MOSFETs, such as voltage- and current-fed full-bridge converters or a boost converter with an autotransformer. The MOSFET-based dc/dc converters must be connected in series to a VSI with IGBTs to feed into the three-phase grid. The presented converters were tested in the laboratory. Some characteristics of their laboratory performance are shown. [ABSTRACT FROM AUTHOR]

Voltage-oriented PI control of three-phase grid- connected pulsewidth-modulation rectifiers with LCL filters is addressed. LCL filters require resonance damping. Active resonance damping is state of the art to face the problem, but it is still under investigation because of the manifold solutions. It is often realized using many sensors and/or complex control algorithms. In contrast, pure PI control requires only one set of current sensors, and its implementation and design are rather simple and well known from the L filter control. PI control has already been shown to be a suitable solution also for LCL filters, but there are limitations. These are investigated in this paper. System stability is analyzed with respect to different ratios of LCL filter resonance and control frequencies. The latter are important parameters for system design and control. Both line and converter current control are analyzed. For a certain range of frequency ratios, the voltage.oriented PI control gives stable performance without additional feedback, but for ratios outside this range, stable operation is impossible. Experimental tests validate the theoretical results. In addition, an experimentally determined LCL filter transfer function is shown in this paper, which shows a lower resonance peak as expected from commonly used filter models. [ABSTRACT FROM AUTHOR]

DC-link current harmonics are the predominant factor to be considered for dimensioning dc capacitors in three-phase pulsewidth-modulation (PWM) voltage-source converters. In this paper, an analysis of the dc-link current harmonics applying a double Fourier series is derived. The analytical results for the dc-link current spectra of continuous and discontinuous PWMs are presented and compared with measurement results taken from a converter test setup. A good match between theoretically expected and actually obtained experimental results can be stated. Moreover, characteristic differences between the investigated modulation strategies regarding their dc-link current spectra become evident. [ABSTRACT FROM AUTHOR]