Search

This paper presents the effect of stray capacitances in bipolar (negative and/or positive) pulses generated by the two different topologies of the solid-state Marx modulators. According to the analysis, the stray capacitances influence the energy transfer from the Marx modulator capacitors to the load affecting the bipolar (negative and/or positive) pulse rise time. This paper deals with the structure design to reduce the influence of the stray capacitance and to improve the pulse rise time of these bipolar solid-state Marx modulators. A four-stage laboratory prototype of the two topologies has been assembled using 1200-V insulated gate bipolar transistors and diodes, operating with 1000-V dc input voltage and 1-kHz frequency, producing 4-kV bipolar pulses, with 5- \mu \texts pulse duration and 120-ns rise time, into a resistive load. [ABSTRACT FROM PUBLISHER]

Two solid-state bipolar Marx modulators are analyzed and compared regarding hold-off semiconductor voltages and open-fault tolerance capability. Normal and abnormal operating conditions are considered, such as switch synchronization mismatches, failures, and open faults. Ten-stage laboratory prototypes of two bipolar Marx modulators have been assembled using 1200-V insulated gate bipolar transistors and matching diodes, to operate at 500-V dc input voltage. Outputs are 4-kV bipolar pulses, 1% duty ratio, into resistive loads, and 1-kHz frequency. Lack of synchronization and open-fault tests confirm that only topologies with redundant switches can operate without semiconductors being subjected to double hold-off voltages while presenting current paths to clear faults. [ABSTRACT FROM PUBLISHER]

This paper presents a novel technique for the voltage droop compensation of long pulses in solid-state bipolar high-voltage Marx generators. Considering the modularity of Marx generators the compensation consists in adding one extra stage to perform as a pulsewidth modulation circuit. This stage voltage is added to the output positive or negative pulses, and an output LfCf filter is included to smooth the voltage pulse waveform. A five-stage laboratory prototype of this circuit has been assembled using 1200-V Insulated Gate Bipolar Transistors and diodes with 1000-V dc input voltage. The circuit was operated at 50-Hz bipolar pulse rate, giving 4-kV bipolar pulses, into a resistive load, with 100- \mu \texts pulsewidth and 9.5-ms relaxation time. The circuit was able to compensate 10% of bipolar pulse voltage droop. [ABSTRACT FROM PUBLISHER]

This paper describes a solid-state asymmetric bridge resonant topology to increase the energy efficiency of switching pulse modulators. The solid-state resonant topology will replace an existing pulse transformer and thyratron-based resonant modulator to supply the 60-kV target potential for the ion acceleration of the On-Line Isotope Mass Separator ISOLDE accelerator. An experimental prototype is tested in order to validate the proposed concept, including a low auxiliary voltage power supply to compensate the losses in the circuit. The design of the circuit components and the experimental results for a 6-kV prototype are presented and discussed, as well as the design procedure and parameters for the 60-kV modulator, including a high-voltage gapped coil core. [ABSTRACT FROM AUTHOR]