Search

This paper presents an accurate steady-state initialization method for electromagnetic transient (EMT) models of modular multilevel converters (MMCs). The proposed method uses steady-state arm voltages and currents to initialize internal electrical variables and control systems of the converter, including capacitor voltage and gating signals of each sub-module. In addition to typical voltage source converter upper level control, MMC specific controls are also considered, including circulating current control, dc ripple control, and capacitor voltage balancing algorithm. EMT simulations on 101-level and 401-level MMC-HVDC systems confirm the accuracy of the proposed method. [ABSTRACT FROM AUTHOR]

When investigating voltage and current stresses in critical main circuit components during faults of the converter, a detailed equivalent model capable of representing the balancing control strategies of the capacitor voltages on the submodule level, along with blocking and delocking, is always necessary. Among previously proposed equivalent models of the modular multilevel converter (MMC), only submodule averaged models (SAMs) can capture interested inner dynamics inside each arm. However, the simulation accuracy of SAMs is not always satisfactory, especially when the time step is larger than 10 $\mu$s. In order to further improve the simulation accuracy with guaranteed simulation efficiency, the shifted frequency modeling of the half- and full-bridge hybrid MMC is proposed in this paper. Therein, each submodule is represented by Thévenin equivalents derived by submodule dynamic phasors. The arm of the MMC is represented by Norton equivalents to guarantee the efficiency, considering both normal and dc-blocking conditions. The effectiveness of the proposed model in terms of accuracy and efficiency is validated by simulating an MMC-based HVdc transmission. [ABSTRACT FROM AUTHOR]

Plug-in electric vehicle (PEV) charging equipment incorporates protection that ensures that grid disturbances do not damage the charger or vehicle. When the grid voltage sags below 80% of nominal, undervoltage protection is likely to disconnect the charging load from the grid. Most PEV charging will occur overnight, when non-PEV load is at a minimum. This paper argues that PEV voltage-sag response, when synchronized across large numbers of PEVs, could result in the loss of a significant proportion of the total load. It is shown that this load loss can lead to unacceptably high voltages once the initiating event has been cleared. This paper explores the nature of this voltage-rise phenomenon. Analysis tools are developed to assist in determining PEV loading conditions that demarcate acceptable postdisturbance voltage response from unacceptable outcomes. Two examples, based on standard distribution test systems, are used to illustrate PEV-induced overvoltage behavior, and demonstrate applications of the analysis tools. [ABSTRACT FROM AUTHOR]