Search

The mobile south flank of Kīlauea Volcano hosts two normal fault systems, the Koa'e fault system (KFS) and the Hilina fault system (HFS). In historical time, at least three M>6.5 earthquakes have occurred on the basal detachment of the Kīlauea Volcano's south flank, with the most recent being the 4 May 2018 M6.9 earthquake. Here we analyze kinematic Global Positioning System data collected from 2001 to 2017 and interferometric synthetic aperture radar data before, during, and after the 2018 M6.9 earthquake to determine the crustal motion across the HFS and KFS faults. Our results indicate that the HFS faults did not significantly slip during the interseismic period from 2007 to 2011. Despite its substantial magnitude, interferometric synthetic aperture radar (InSAR) data show that the 2018 M6.9 earthquake triggered subcentimeter level slip along sections of the previously mapped HFS branches. Up to 20 cm of offset occurred on what appears to be a newly formed (or previously unknown) fault near the eastern end of the HFS. During the 3 months following the M6.9 earthquake, up to ~30 cm of slip occurred along the KFS, which helps accommodate rapid large‐scale subsidence of Kīlauea's summit region as large volumes of summit reservoir magma fed the lower East Rift Zone eruption. The HFS appears to activate only in concert with large earthquakes on the basal detachment. The KFS, on the other hand, moves both seismically during small local earthquakes and aseismically in response to nearby earthquakes and caldera subsidence.

Continuous gravity data collected near the summit eruptive vent at Kīlauea Volcano, Hawaiʻi, during 2011–2015 show a strong correlation with summit-area surface deformation and the level of the lava lake within the vent over periods of days to weeks, suggesting that changes in gravity reflect variations in volcanic activity. Joint analysis of gravity and lava level time series data indicates that over the entire time period studied, the average density of the lava within the upper tens to hundreds of meters of the summit eruptive vent remained low—approximately 1000–1500 kg/m3. The ratio of gravity change (adjusted for Earth tides and instrumental drift) to lava level change measured over 15 day windows rose gradually over the course of 2011–2015, probably reflecting either (1) a small increase in the density of lava within the eruptive vent or (2) an increase in the volume of lava within the vent due to gradual vent enlargement. Superimposed on the overall time series were transient spikes of mass change associated with inflation and deflation of Kīlauea's summit and coincident changes in lava level. The unexpectedly strong mass variations during these episodes suggest magma flux to and from the shallow magmatic system without commensurate deformation, perhaps indicating magma accumulation within, and withdrawal from, void space—a process that might not otherwise be apparent from lava level and deformation data alone. Continuous gravity data thus provide unique insights into magmatic processes, arguing for continued application of the method at other frequently active volcanoes.

Analysis of microgravity and surface displacement data collected at the summit of Kīlauea Volcano, Hawaii (USA), between December 2009 and November 2012 suggests a net mass accumulation at ~1.5 km depth beneath the northeast margin of Halema‘uma‘u Crater, within Kīlauea Caldera. Although residual gravity increases and decreases are accompanied by periods of uplift and subsidence of the surface, respectively, the volume change inferred from the modeling of interferometric synthetic aperture radar deformation data can account for only a small portion (as low as 8%) of the mass addition responsible for the gravity increase. We propose that since the opening of a new eruptive vent at the summit of Kīlauea in 2008, magma rising to the surface of the lava lake outgasses, becomes denser, and sinks to deeper levels, replacing less dense gas-rich magma stored in the Halema‘uma‘u magma reservoir. In fact, a relatively small density increase (

Differencing digital elevation models (DEMs) derived from TerraSAR add-on for Digital Elevation Measurements (TanDEM-X) synthetic aperture radar imagery provides a measurement of elevation change over time. On the East Rift Zone (EZR) of Kīlauea Volcano, Hawai‘i, the effusion of lava causes changes in topography. When these elevation changes are summed over the area of an active lava flow, it is possible to quantify the volume of lava emplaced at the surface during the time spanned by the TanDEM-X data—a parameter that can be difficult to measure across the entirety of an ~100 km2 lava flow field using ground-based techniques or optical remote sensing data. Based on the differences between multiple TanDEM-X-derived DEMs collected days to weeks apart, the mean dense-rock equivalent time-averaged discharge rate of lava at Kīlauea between mid-2011 and mid-2013 was approximately 2 m3/s, which is about half the long-term average rate over the course of Kīlauea's 1983–present ERZ eruption. This result implies that there was an increase in the proportion of lava stored versus erupted, a decrease in the rate of magma supply to the volcano, or some combination of both during this time period. In addition to constraining the time-averaged discharge rate of lava and the rates of magma supply and storage, topographic change maps derived from space-based TanDEM-X data provide insights into the four-dimensional evolution of Kīlauea's ERZ lava flow field. TanDEM-X data are a valuable complement to other space-, air-, and ground-based observations of eruptive activity at Kīlauea and offer great promise at locations around the world for aiding with monitoring not just volcanic eruptions but any hazardous activity that results in surface change, including landslides, floods, earthquakes, and other natural and anthropogenic processes.

[1] Multiple mechanisms have been suggested to explain seaward motion of the south flank of Kīlauea Volcano, Hawai‘i. The consistency of flank motion during both waxing and waning magmatic activity at Kīlauea suggests that a continuously acting force, like gravity body force, plays a substantial role. Using finite element models, we test whether gravity is the principal driver of long-term motion of Kīlauea's flank. We compare our model results to geodetic data from Global Positioning System and interferometric synthetic aperture radar during a time period with few magmatic and tectonic events (2000–2003), when deformation of Kīlauea was dominated by summit subsidence and seaward motion of the south flank. We find that gravity-only models can reproduce the horizontal surface velocities if we incorporate a regional decollement fault and a deep, low-viscosity magma mush zone. To obtain quasi steady state horizontal surface velocities that explain the long-term seaward motion of the flank, we find that an additional weak zone is needed, which is an extensional rift zone above the magma mush. The spreading rate in our model is mainly controlled by the magma mush viscosity, while its density plays a less significant role. We find that a viscosity of 2.5 × 1017–2.5 × 1019 Pa s for the magma mush provides an acceptable fit to the observed horizontal surface deformation. Using high magma mush viscosities, such as 2.5 × 1019 Pa s, the deformation rates remain more steady state over longer time scales. These models explain a significant amount of the observed subsidence at Kīlauea's summit. Some of the remaining subsidence is probably a result of magma withdrawal from subsurface reservoirs.

[1] The 5–9 March 2011 Kamoamoa fissure eruption along the east rift zone of Kīlauea Volcano, Hawai`i, followed months of pronounced inflation at Kīlauea summit. We examine dike opening during and after the eruption using a comprehensive interferometric synthetic aperture radar (InSAR) data set in combination with continuous GPS data. We solve for distributed dike displacements using a whole Kīlauea model with dilating rift zones and possibly a deep decollement. Modeled surface dike opening increased from nearly 1.5 m to over 2.8 m from the first day to the end of the eruption, in agreement with field observations of surface fracturing. Surface dike opening ceased following the eruption, but subsurface opening in the dike continued into May 2011. Dike volumes increased from 15, to 16, to 21 million cubic meters (MCM) after the first day, eruption end, and 2 months following, respectively. Dike shape is distinctive, with a main limb plunging from the surface to 2–3 km depth in the up-rift direction toward Kīlauea's summit, and a lesser projection extending in the down-rift direction toward Pu`u `Ō`ō at 2 km depth. Volume losses beneath Kīlauea summit (1.7 MCM) and Pu`u `Ō`ō (5.6 MCM) crater, relative to dike plus erupted volume (18.3 MCM), yield a dike to source volume ratio of 2.5 that is in the range expected for compressible magma without requiring additional sources. Inflation of Kīlauea's summit in the months before the March 2011 eruption suggests that the Kamoamoa eruption resulted from overpressure of the volcano's magmatic system.

[1] Leveling surveys of a 193-km circuit across Medicine Lake volcano (MLV) in 1954 and 1989 show that the summit area subsided by as much as 302 ± 30 mm (−8.6 ± 0.9 mm/yr) with respect to a datum point near Bartle, California, 40 km to the southwest. This result corrects an error in the earlier analysis of the same data by Dzurisin et al. [1991], who reported the subsidence rate as −11.1 ± 1.2 mm/yr. The subsidence pattern extends across the entire volcano, with a surface area of nearly 2000 km2. Two areas of localized subsidence by as much as 20 cm can be attributed to shallow normal faulting near the volcano's periphery. Surveys of an east–west traverse across Lava Beds National Monument on the north flank of the volcano in 1990 and of a 23-km traverse across the summit area in 1999 show that subsidence continued at essentially the same rate during 1989–1999 as 1954–1989. Volcano-wide subsidence can be explained by either a point source of volume loss (Mogi) or a contracting horizontal rectangular dislocation (sill) at a depth of 10–11 km. Volume loss rate estimates range from 0.0013 to 0.0032 km3/yr, depending mostly on the source depth estimate and source type. Based on first-order quantitative considerations, we can rule out that the observed subsidence is due to volume loss from magma withdrawal, thermal contraction, or crystallizing magma at depth. Instead, we attribute the subsidence and faulting to: (1) gravitational loading of thermally weakened crust by the mass of the volcano and associated intrusive rocks, and (2) thinning of locally weakened crust by Basin and Range deformation. The measured subsidence rate exceeds long-term estimates from drill hole data, suggesting that over long timescales, steady subsidence and episodic uplift caused by magmatic intrusions counteract each other to produce the lower net subsidence rate.