Search

Digital light processing 3D printing can be applied to fabricate complex silicon nitride (Si 3 N 4) components. However, because of the surface hydroxyl groups and large refractive index, it is still a foremost challenge to realize a stable photosensitive Si 3 N 4 slurry with combined benefits of low viscosity and large curing depth. In this study, we propose a new formulation strategy to prepare Si 3 N 4 slurry. Starting from the optimization of monomer ratio, we have systematically optimized powder particle size, dispersant and photoinitiator on the rheological properties and curing properties of Si 3 N 4 slurry. Specifically, we have fabricated a stable photosensitive Si 3 N 4 slurry (48 vol%) with a viscosity of 2.09 Pa s (30 s−1), a critical curing energy of 126.09 mJ/cm2 and a maximum curing depth of 80 µm. Finally, based on this optimized slurry, we have successfully obtained complex Si 3 N 4 green body with no defect, which demonstrates great potential to fabricate arbitrary complex ceramic components for various applications. [ABSTRACT FROM AUTHOR]

We developed a newly-designed TiN/AgCuTi composite brazing alloy to significantly improve the bonding strength of AlN/Cu composite ceramics, which can endow high power electronic devices with superior compatibility with large current transport and high voltage resistance. Via the systematic microstructure investigation of the brazed joint by scanning electron microscopy and X-ray diffractometer, we found that added TiN particles could decrease the thickness of brittle reaction layer and promote the formation of fine TiCu particles in brazed joint, leading to dispersion strengthened and decreased CTE mismatch of the ceramic/metal composite. Importantly, the maximum bonding strength of 131 MPa was obtained for AlN and copper foil brazed joining via composite filler with TiN(4 wt.%)/AgCuTi, which is approximately 150 % higher than the case without TiN addition. [ABSTRACT FROM AUTHOR]

The ability of Hypermer KD1 to disperse high solids loading reaction sialon suspensions for slip casting has been characterised. It has been found to be a very effective dispersant in organic media of 60-vol.% MEK and 40-vol.% Ethanol, yielding fluid and highly homogeneous suspensions. The effects of added amounts of KD1 have been observed through adsorption data, sedimentation tests and rheology measurements. KD1 imparts low viscosity and stability to the suspension. It has been found that 3-wt.% addition of KD1, based on the weight of reaction sialon powders, results in a very stable and high flowable suspension with near Newtonian flow behavior. Less amounts of dispersant lead to unstable suspensions with obvious shear thinning flow behaviors, while adding excessive dispersant leads to high viscosities, especially at high solids loading. Measuring the pore size distribution of green bodies from different suspensions has proved the effects of dispersant amounts on dispersing the slurries and on slip casting performance. [Copyright &y& Elsevier]

Effects of Li2O on the densification and the thermal conductivity of AlN ceramics sintered at a low temperature were studied by using Li2CO3, CaF2 and Y2O3 as additives. DTA and XRD were employed to identify the formation of the liquid and the changes of the phase compositions during the sintering. SEM and TEM were used to observe the microstructures of AlN specimens sintered at 1650 °C. The results show that Li2O is an effective sintering aid, leading to high densification and high thermal conductivity at low sintering temperatures. AlN specimens with full densification and thermal conductivity were achieved with Li2O addition. The high densification comes from the promotion of the liquid containing Li and CaYAlO4. The high thermal conductivity is attributed to the purification of the AlN lattice, the enhancement of the density and the elimination of some grain-boundary phases. [Copyright &y& Elsevier]