Search

This article presents an online condition monitoring (CM) scheme for semiconductors used in modular multilevel converters (MMCs) that comprise cascaded H-bridge submodules. The CM algorithm is based on detecting changes in the on-state resistance of the semiconductors over time. The proposed method is shown to successfully perform a curve tracing of semiconductors in MMCs while the semiconductor junction remains at a temperature that is readily measurable and undergoes minute changes during the measurement process. The on-state resistance value is estimated from the measured on-state voltage drop of the semiconductors and the measured arm current. Measuring the on-state resistance at known temperatures allows for separating temperature-dependent variations of the on-state resistance from age-dependent variations of this parameter. Suitable methods for reducing the effect of noise on the curve-traced data are proposed, and a recursive least square estimator is used to extract the optimum on-state resistance from the traced vCE-iC curve. Simulation results show that the proposed scheme can accurately determine the on-state resistance of semiconductors at a known temperature and under various levels of measurement noise. Moreover, experimental results on a low-power prototype show that the proposed scheme is applicable in practice, and provides similar online curves to what a commercial curve tracer can produce offline. The experimental verification has been conducted under constant load conditions; however, the proposed methods can be used under any variable load condition as well.

The wireless control of modular multilevel converter (MMC) submodules was recently proposed. The success of the control depends on specialized control methods suitable for wireless communication and a properly designed wireless communication network in the MMC valve hall while aiming for low latency and high reliability. The wireless communication in the hall can be affected by the electromagnetic interference (EMI) of MMC submodules, voltage and current transients. In this article, firstly, a wireless communication network based on 5G New Radio is designed for an example full-scale MMC valve hall. After that, the radiated EMI characteristics of the MMC submodules with different voltage and current ratings and two dc circuit breakers are measured. The effects of EMI on wireless communication in the multi-GHz frequency band are tested. The interference from the components is confined below 500 MHz, and the wireless communication with 5825 MHz center frequency is not affected by the interference. QC 20220502

Wireless control of modular multilevel converter (MMC) submodules can benefit from different points of view, such as lower converter cost and shorter installation time. In return for the advantages, the stochastic performance of wireless communication networks necessitates an advanced converter control system immune to the losses and delays of the wirelessly transmitted data. This paper proposes an advancement to the distributed control of MMCs to utilize in wireless submodule control. Using the proposed method, the operation of the MMC continues smoothly and uninterruptedly during wireless communication errors. The previously proposed submodule wireless control concept relies on implementing the modulation and individual submodule-capacitor-voltage control in the submodules using the insertion indices transmitted from a central controller. This paper takes the concept as a basis and introduces to synthesize the indices autonomously in the submodules during the communication errors. This new approach allows the MMC continue its operation when one, some, or all submodules suffer from communication errors for a limited time. The proposal is validated experimentally on a laboratory-scale MMC. QC 20220627