Search

The micro-discharge effect limits the development of high-frequency microwave power components to miniaturization and integration. Therefore, it has become a focus of research to effectively suppress the micro-discharge effect, increase the micro-discharge threshold, and strengthen the environmental stability of high-frequency microwave devices. In this study, different elemental ratios of carbon (C)/silver (Ag)/titanium (Ti) composite films were obtained by multi-target magnetron co-sputtering technology and then systematically analyzed for micro-discharge effects. When the doping ratio of C/Ag/Ti was 3.538/1/0.013, the corresponding maximum secondary electron emission coefficient (δmax) decreased to 1.01 owing to the suppression of secondary electron emission by the increase in the content of sp2 hybrid bond. The micro-discharge threshold of Ku band waveguide filters coated with moderate C/Ag/Ti composite films showed an optimal performance of 10 000−12 500 W, which was increased by approximately 20 times. Moreover, the microstructure of the composite films exhibited higher density and flatness with a tiny increase in the titanium doping ratio, representing good environmental stability. Thus, the effective suppression of the secondary electron emission yield, significant improvement in the micro-discharge threshold, and enhancement of the environment stability of microwave components could be realized simultaneously by reasonably controlling the content of titanium in silver and titanium co-doped carbon-based composite films. [ABSTRACT FROM AUTHOR]

Wireless strain sensors have received extensive attention owing to their wide application prospects in structural health monitoring, industrial automation, human activity monitoring, and intelligent robotic systems. Here, a wireless strain sensor prototype based on the magnetoelectric heterostructure of ferromagnetic thin films on a piezoelectric substrate has been developed. The ferromagnetic resonance (FMR) frequency of the sensor is strongly dependent on external strain due to the large magnetostriction of the film. The piezoelectric substrate with a programmable voltage has been used as a strain source for the characterization of the wireless strain sensor. The limit of detection of the wireless strain sensor is 0.54 με, which is comparable with that of commercial metal-foil sensors that need connection wires. More importantly, the FMR strain sensor shows a sensitivity of 65.46 ppm/με, indicating more than a 60 fold improvement than that of traditional wireless strain sensors based on patch antenna and RLC resonators whose frequency shift is mainly due to the strain induced dimension change. [ABSTRACT FROM AUTHOR]