Search

The real-time identification of protein biomarkers is crucial for the development of point-of-care and portable devices. Here, we use a PlyAB biological nanopore to detect haemoglobin (Hb) variants. Adult haemoglobin (HbA) and sickle cell anaemia haemoglobin (HbS), which differ by just one amino acid, were distinguished in a mixture with more than 97 % accuracy based on individual blockades. Foetal Hb, which shows a larger sequence variation, was distinguished with near 100 % accuracy. Continuum and Brownian dynamics simulations revealed that Hb occupies two energy minima, one near the inner constriction and one at the trans entry of the nanopore. Thermal fluctuations, the charge of the protein, and the external bias influence the dynamics of Hb within the nanopore, which in turn generates the unique ionic current signal in the Hb variants. Finally, Hb was counted from blood samples, demonstrating that direct discrimination and quantification of Hb from blood using nanopores, is feasible. ispartof: ANGEWANDTE CHEMIE-INTERNATIONAL EDITION vol:61 issue:34 ispartof: location:Germany status: published

Single-molecule nanopore electrophysiology is an emerging technique for the detection of analytes in aqueous solutions with high sensitivity. These detectors have proven applicable for the enzyme-assisted sequencing of oligonucleotides. There has recently been an increased interest in the use of nanopores for the fingerprinting of peptides and proteins, referred to as single-molecule nanopore spectrometry. However, the analysis of the resulting electrophysiology traces remains complicated due to the fast unassisted translocation of such analytes, usually in the order of micro- to milliseconds, and the small ion current signal produced (in the picoampere range). Here, we present the application of a generalized normal distribution function (gNDF) for the characterization of short-lived ion current signals (blockades). We show that the gNDF can be used to determine if the observed blockades have adequate time to reach their maximum current plateau while also providing a description of each blockade based on the open pore current (I O), the difference caused by the pore blockade (ΔI B), the position in time (μ), the standard deviation (σ), and a shape parameter (β), leaving only the noise component. In addition, this method allows the estimation of an ideal range of low-pass filter frequencies that contains maximum information with minimal noise. In summary, we show a parameter-free and generalized method for the analysis of short-lived ion current blockades, which facilitates single-molecule nanopore spectrometry with minimal user bias. ispartof: ACS OMEGA vol:7 issue:30 pages:26040-26046 ispartof: location:United States status: published

We present a synthetic nanoscale piston that uses chemical energy to perform molecular transport against an applied bias. Such a device comprises a 13 by 5 nm protein cylinder, embedded in a biological membrane enclosing a single-stranded DNA (ssDNA) rod. Hybridization with DNA cargo rigidifies the rod, allowing for transport of a selected DNA molecule across the nanopore. A strand displacement reaction from ssDNA fuel on the other side of the membrane then liberates the DNA cargo back into solution and regenerates the initial configuration. The entropic penalty of ssDNA confinement inside the nanopore drives DNA transport regardless of the applied bias. Multiple automated and reciprocating cycles are observed, in which the DNA piston moves through the 10 nm length of the nanopore. In every cycle, a single DNA molecule is transported across the nanopore against an external bias force, which is the hallmark of biological transporters. ispartof: NANO LETTERS vol:21 issue:1 pages:762-768 ispartof: location:United States status: published

Biological nanopores are emerging as powerful tools for single-molecule analysis and sequencing. Here, we engineered the two-component pleurotolysin (PlyAB) toxin to assemble into 7.2 × 10.5 nm cylindrical nanopores with a low level of electrical noise in lipid bilayers, and we addressed the nanofluidic properties of the nanopore by continuum simulations. Surprisingly, proteins such as human albumin (66.5 kDa) and human transferrin (76-81 kDa) did not enter the nanopore. We found that the precise engineering of the inner surface charge of the PlyAB induced electro-osmotic vortices that allowed the electrophoretic capture of the proteins. Once inside the nanopore, two human plasma proteins could be distinguished by the characteristics of their current blockades. This fundamental understanding of the nanofluidic properties of nanopores provides a practical method to promote the capture and analysis of folded proteins by nanopores. ispartof: NANO LETTERS vol:20 issue:5 pages:3819-3827 ispartof: location:United States status: published

ispartof: 2022 INTERNATIONAL ELECTRON DEVICES MEETING, IEDM ispartof: International Electron Devices Meeting (IEDM) location:CA, San Francisco date:3 Dec - 7 Dec 2022 status: published

Despite the broad success of biological nanopores as powerful instruments for the analysis of proteins and nucleic acids at the single-molecule level, a fast simulation methodology to accurately model their nanofluidic properties is currently unavailable. This limits the rational engineering of nanopore traits and makes the unambiguous interpretation of experimental results challenging. Here, we present a continuum approach that can faithfully reproduce the experimentally measured ionic conductance of the biological nanopore Cytolysin A (ClyA) over a wide range of ionic strengths and bias potentials. Our model consists of the extended Poisson-Nernst-Planck and Navier-Stokes (ePNP-NS) equations and a computationally efficient 2D-axisymmetric representation for the geometry and charge distribution of the nanopore. Importantly, the ePNP-NS equations achieve this accuracy by self-consistently considering the finite size of the ions and the influence of both the ionic strength and the nanoscopic scale of the pore on the local properties of the electrolyte. These comprise the mobility and diffusivity of the ions, and the density, viscosity and relative permittivity of the solvent. Crucially, by applying our methodology to ClyA, a biological nanopore used for single-molecule enzymology studies, we could directly quantify several nanofluidic characteristics difficult to determine experimentally. These include the ion selectivity, the ion concentration distributions, the electrostatic potential landscape, the magnitude of the electro-osmotic flow field, and the internal pressure distribution. Hence, this work provides a means to obtain fundamental new insights into the nanofluidic properties of biological nanopores and paves the way towards their rational engineering. ispartof: NANOSCALE vol:12 issue:32 pages:16775-16795 ispartof: location:England status: published

In recent years, the protein nanopore cytolysin A (ClyA) has become a valuable tool for the detection, characterization and quantification of biomarkers, proteins and nucleic acids at the single-molecule level. Despite this extensive experimental utilization, a comprehensive computational study of ion and water transport through ClyA is currently lacking. Such a study yields a wealth of information on the electrolytic conditions inside the pore and on the scale the electrophoretic forces that drive molecular transport. To this end we have built a computationally efficient continuum model of ClyA which, together with an extended version of Poison-Nernst-Planck-Navier-Stokes (ePNP-NS) equations, faithfully reproduces its ionic conductance over a wide range of salt concentrations. These ePNP-NS equations aim to tackle the shortcomings of the traditional PNP-NS models by self-consistently taking into account the influence of both the ionic strength and the nanoscopic scale of the pore on all relevant electrolyte properties. In this study, we give both a detailed description of our ePNP-NS model and apply it to the ClyA nanopore. This enabled us to gain a deeper insight into the influence of ionic strength and applied voltage on the ionic conductance through ClyA and a plethora of quantities difficult to assess experimentally. The latter includes the cation and anion concentrations inside the pore, the shape of the electrostatic potential landscape and the magnitude of the electro-osmotic flow. Our work shows that continuum models of biological nanopores—if the appropriate corrections are applied—can make both qualitatively and quantitatively meaningful predictions that could be valuable tool to aid in both the design and interpretation of nanopore experiments.

The ability to confine and to study single molecules has enabled important advances in natural and applied sciences. Recently, we have shown that unlabeled proteins can be confined inside the biological nanopore Cytolysin A (ClyA) and conformational changes monitored by ionic current recordings. However, trapping small proteins remains a challenge. Here, we describe a system where steric, electrostatic, electrophoretic, and electro-osmotic forces are exploited to immobilize a small protein, dihydrofolate reductase (DHFR), inside ClyA. Assisted by electrostatic simulations, we show that the dwell time of DHFR inside ClyA can be increased by orders of magnitude (from milliseconds to seconds) by manipulation of the DHFR charge distribution. Further, we describe a physical model that includes a double energy barrier and the main electrophoretic components for trapping DHFR inside the nanopore. Simultaneous fits to the voltage dependence of the dwell times allowed direct estimates of the cis and trans translocation probabilities, the mean dwell time, and the force exerted by the electro-osmotic flow on the protein (≅9 pN at -50 mV) to be retrieved. The observed binding of NADPH to the trapped DHFR molecules suggested that the engineered proteins remained folded and functional inside ClyA. Contact-free confinement of single proteins inside nanopores can be employed for the manipulation and localized delivery of individual proteins and will have further applications in single-molecule analyte sensing and enzymology studies. ispartof: ACS NANO vol:13 issue:9 pages:9980-9992 ispartof: location:United States status: published

Many important processes in biology involve the translocation of a biopolymer through a nanometer-scale pore. Moreover, the electrophoretic transport of DNA across nanoscale pores is under intense investigation for single-molecule DNA sequencing and analysis. Here we show that the precise patterning of the entry and the middle section of the ClyA nanopore with positive charges are crucial to observe the electrophoretic translocation of DNA at physiological ionic strength. Surprisingly, the strongly electronegative 3.3 nm internal constriction of the nanopore did not require modifications. Further, DNA translocation could only be observed from the wide entry of the nanopore. Our results suggest that the engineered positive charges are important to align the DNA in order to overcome the entropic and electrostatic barriers for DNA translocation through the narrow constriction. The dependencies of nucleic acid translocations on the Debye length of the solution are consistent with a physical model where the capture of double stranded DNA is diffusion-limited while the capture of single stranded DNA is reaction-limited.

Biological nanopores are a class of membrane proteins that open nanoscale water conduits in biological membranes. When they are reconstituted in artificial membranes and a bias voltage is applied across the membrane, the ionic current passing through individual nanopores can be used to monitor chemical reactions, to recognize individual molecules and, of most interest, to sequence DNA. In addition, a more recent nanopore application is the analysis of single proteins and enzymes. Monitoring enzymatic reactions with nanopores, i.e. nanopore enzymology, has the unique advantage that it allows long-timescale observations of native proteins at the single-molecule level. Here, we describe the approaches and challenges in nanopore enzymology. This article is part of the themed issue ‘Membrane pores: from structure and assembly, to medicine and technology’.

Protein assembly plays an important role throughout all phyla of life, both physiologically and pathologically. In particular, aggregation and polymerization of proteins are key-strategies that regulate cellular function. In recent years, methods to experimentally study the assembly process on a single-molecule level have been developed. This progress concomitantly has triggered the question of how to analyze this type of single-filament data adequately and what experimental conditions are necessary to allow a meaningful interpretation of the analysis. Here, we developed two analysis methods for single-filament data: the visitation analysis and the average-rate analysis. We benchmarked and compared both approaches with the classic dwell-time-analysis frequently used to study microscopic association and dissociation rates. In particular, we tested the limitations of each analysis method along the lines of the signal-to-noise ratio, the sampling rate, and the labeling efficiency and bleaching rate of the fluorescent dyes used in single-molecule fluorescence experiments. Finally, we applied our newly developed methods to study the monomer assembly of actin at the single-molecule-level in the presence of the class II nucleator Cappuccino and the WH2 repeats of Spire. For Cappuccino, our data indicated fast elongation circumventing a nucleation phase whereas, for Spire, we found that the four WH2 motifs are not sufficient to promote de novo nucleation of actin. ispartof: SCIENTIFIC REPORTS vol:12 issue:1 ispartof: location:England status: published