Search

The precipitation behavior of the multicomponent Al–6Mg–9Si–10Cu–10Zn–3Ni (wt%) alloy was investigated during artificial aging at 120 °C through complementary experimental methods including hardness and electrical resistivity measurements, compression testing, differential scanning calorimetry, and transmission electron microscopy. The solution treatment causes the dissolution of the preexisting θ-Al 2 Cu and hcp Zn phases, thereby increasing the concentrations of Zn and Cu species in the Al matrix. During aging, two resistivity peaks (I R , II R ) become visible followed by the appearance of the related hardness peaks (I H , II H ). Spherical Guinier-Preston (GP) zones are formed first and then subsequently transformed into ellipsoidal GP zones. The former process results in the appearance of the I R peak, while the latter process produces the I H peak. During transformation of the ellipsoidal GP zones to hcp Zn, GPI zones are additionally formed, leading to the appearance of II R . The following transformation of the GPI zones into the θ''-Al 3 Cu phase leads to the appearance of the II H peak. Both the ellipsoidal GP zones and hcp Zn phases contain large quantities of Cu atoms, while the θ''-Al 3 Cu phase does not have any Zn atoms. Based on these insights into the structural and chemical compositional evolution of complex precipitates, the strengthening mechanism of the multicomponent alloy during aging has been established. [ABSTRACT FROM AUTHOR]

This paper shows that the addition of transition elements significantly influences the microstructure and tensile properties of Al–12Si alloy cast under ultrasonic melt treatment (UST). The alloys contained primary Si, eutectic Si and a variety of intermetallic compounds (IMCs); the addition of Mn and Ni changed the solidification sequence by forming primary α-Al 15 (Fe,Mn) 4 Si 2 and ε-Al 3 Ni prior to primary Si formation. The primary Si and primary IMCs competitively consumed the nucleation sites introduced by UST, thereby influencing their refining efficiencies; the efficiency of primary Si refinement by UST increased with increasing the fraction of primary Si formed prior to IMC formation, whereas it deteriorated with increasing primary IMC fraction. The refining efficiency of eutectic Si and eutectic IMCs was not affected by the type and fraction of the primary phase. Using a Ti sonotrode for UST caused Ti contamination, resulting in grain refinement by forming Ti(Al,Si) 3 particles and increasing the amount of Ti solutes. Regardless of transition elements content, the application of UST improved the tensile strength at 25 °C and 350 °C. The refinement of IMCs caused by UST allowed the alloy to contain more IMCs without deterioration of room-temperature tensile strength. This enhanced the increment of high-temperature tensile strength by IMCs. Ductility of heavily alloyed systems was also improved by UST. [ABSTRACT FROM AUTHOR]