Search

For the implementation of the requirements in the Council Directive 2013/59/Euratom (2013 EUBSS), the cost-effectiveness analysis (CEA) is generally considered a useful tool to compare different radon policies aimed at reducing radon exposure both at home and at work. In the framework of the EU funded RADPAR project, a methodology to perform CEA analysis of radon control in dwellings was developed - and used also for WHO's radon recommendations of 2009 - and it is based on the evaluation of the health effectiveness in terms of life years and/or QALYs (Quality Adjusted Life Years) gained. In this work, starting from the RADPAR model used for dwellings, a so-called RADPAR4workplaces model was developed to carry out CEA focused on reduction of radon exposure at workplaces. In particular, different radon policies in existing workplaces were considered and their cost-effectiveness were estimated, as a case study, for the Italian retail shops located at ground floor. Main results show that a policy that requires remedial actions where radon concentration is above a certain reference level (RL) and that recommends them also below this RL has a good cost-effectiveness ratio and it is more effective than a policy with no provisions for radon levels below RL. In particular, the further implementation of remediation below RL improves the health effectiveness increasing QALYs gained of 20% while cost per QALY increases of only 14%. Finally, promoting the remediation of workplaces below RL, QALYs gained and cost per QALY increase of about 80% and 20%, respectively, if remediation rate rises from 10% to 50% below RL., (Copyright © 2021 Elsevier Ltd. All rights reserved.)

In this paper the authors present a collection of radon emanation and exhalation rate data of about 2000 samples of building materials used in Europe. The data analysis highlighted some critical issues, such as the use of different units to express radon exhalation rate, the use of different measurement techniques and the general lack of information about density and thickness of samples. In many cases these differences of type and amount of information make difficult a reliable comparison of the obtained data. In the light of these considerations, the need arises to start, at both national and European level, a research activity aimed to develop a shared protocol for measuring the radon exhalation rate based on widely used and reliable measurement techniques. At European level, this protocol could support in forthcoming EU Member States national radon action plans, to take into account the contribution of building materials to the indoor radon concentrations., (Copyright © 2020 Elsevier Ltd. All rights reserved.)

The recently developed radon film-badge makes it possible to measure radon indoors, in soil, in water and/or in aqueous media (e.g. mud). As a result of its wide response linearity, this monitor has been successfully used to measure radon in-water with concentrations from 10 to ~10 000 Bq/L. By exploiting the unique characteristics of this badge, a mini-survey has been carried out by Health Canada in which radon in water was measured from 12 private wells, as well as in tap water originating from the Ottawa River. Due to the widespread interest of different laboratories in using these passive monitors, laboratories were provided with plastic films to construct their own badges by using in-house CR-39 detectors. Monitors were then irradiated by a known radon concentration at the National Institute of Radiation Metrology (ENEA)'s radon chamber and sent back to each laboratory for processing and counting. Even though these laboratories have been using different etching- and counting-procedures, the film-badge responses varied only within ~12%., (© The Author 2017. Published by Oxford University Press. All rights reserved. For Permissions, please email: journals.permissions@oup.com.)

The final results of radon monitoring in 438 schools located in the province of Lecce (Puglia Region, South Italy) showed an average radon concentration of 215 ± 20 Bq m -3 and that 7% of schools exceeded 500 Bq m -3 , the current Italian action level for radon in workplaces, and consequently required remedial actions. The activity described in the present paper includes the main elements of the remediation project in a subgroup of school buildings. The main radon control systems adopted were sub-slab depressurization (in 57% of schools) and the active ventilation of the crawlspace (in 21% of schools). This experience allows us to put in evidence relevant critical aspects, such as the influence of the karstic nature of the area, the optimization of remediation, the architectural constraints in the case of buildings of architectural or historical interest, which are discussion herein. Moreover, considering the new reference level for radon in workplaces introduced by the new EU Basic Safety Standards, a new analysis of data, achieved in the first survey, highlighted that 20% of schools need to be remediated.

The inhalation of short-lived radon decay products (RDP) yields the greatest contribution to the natural radiation exposure. This paper deals with a study carried out to improve the knowledge of the behaviour of RDPs, their interaction with particulates and the plateout during the time. The tests confirmed that a high aerosol particle concentration increases the probability that an ion sticks to aerosol and remains long in the air, leading to both an increase of F and a decrease of fp, as reported in the literature. The same experimental protocol applied in a small radon chamber showed a strong reduction of the equilibrium factor (an average of ∼10 %), because in a small environment the plateout phenomenon prevails on the attachment to particulate., (© The Author 2014. Published by Oxford University Press. All rights reserved. For Permissions, please email: journals.permissions@oup.com.)

A survey was conducted to evaluate average levels of indoor radon and gamma doses in all educational buildings (506 schools) located in South-East Italy (the Salento peninsula, province of Lecce). In this paper the final findings relating to measurements performed with SSNTD dosemeters in 438 schools (86% of the sample) are reported. The average annual activity concentration of radon in schools located in the province of Lecce is 209 ± 9 Bq/m(3). Radon values actually ranged from 21 Bq/m(3) to 1608 Bq/m(3). About 7% of schools showed radon concentration values above 500 Bq/m(3), the Italian action level for workplaces., (Copyright © 2012 Elsevier Ltd. All rights reserved.)

Etched track detectors are widely used for the detection of radon and its decay products. The reliability of radon measurement performed with such devices requires that laboratories producing analytical data are able to provide results of the required quality. The need for uniform results from laboratories at an international level therefore requires the implementation of a quality assurance programme, the harmonization of criteria, sampling procedures, calculations and the reporting of results, agreed on the basis of fundamental principles and international standards. The quality assurance programme described here is the first step on the way to ISO/IEC 17025 certification for the RI-RN (ISPESL) laboratory.

For workplaces where significant diurnal variations in radon concentrations are likely, measurements to evaluate average radon concentration during working hours could be useful for planning an optimized protection of workers according to the 2013/59/Euratom Directive. However, very few studies on this subject, generally limited to periods of few weeks, have been published. Therefore, a study has been conducted to evaluate the actual long-term radon exposure during working hours for a sample of 33 workplaces of four different types (postal offices, shops, restaurants, municipal offices), mainly located at the ground floor, and with expected considerable air exchange rate occurring during working hours due to frequent entrance/exit of persons or mechanical ventilation. The results show that the difference between the average radon level during working hours and that one during the whole day is about 20% on average and ranges from 0 to 50%. These observed differences, generally smaller compared with those found in other similar studies, are nearly the same if the analysis is restricted to workplaces with annual radon level higher than 300 Bq m–3, and therefore natural or mechanical ventilation normally present during working hours of the monitored workplaces cannot be considered an effective mitigation measure. However, the costs and time-response characteristics of the active monitors, as those used for the present study, will probably allow using more frequently a similar measurement strategy in workplaces. [ABSTRACT FROM AUTHOR]

The paper presents the latest collection of activity concentration data of natural radionuclides ( 226 Ra, 232 Th and 4  K) in building materials. This database contains about 24200 samples of both bulk materials and their constituents (bricks, concrete, cement, aggregates) and superficial materials used in most European Union Member States and some European countries. This collection also includes radiological information about some NORM residues and by-products (by-product gypsum, metallurgical slags, fly and bottom ashes and red mud) which can be of radiological concern if recycled in building materials as secondary raw materials. Moreover, radon emanation and radon exhalation rate data are reported for bricks and concrete. [ABSTRACT FROM AUTHOR]

This paper contains preliminary results of a study on the physical and radiological characterization of concrete samples containing NORM. The natural radionuclides content in term of 226 Ra, 228 Ra, 232 Th, 40 K and the radon exhalation rate of the samples were determined. Two series of samples of concrete were prepared: samples belonging to both series were made of the same basic components (Portland cement CEM I 42,5R as binder, aggregate and plasticizer) but different amount of NORM residues and mineral additives were used. The concrete samples were characterize in term of absolute density, permeability, total and open porosity. The radiological content was evaluated by using gamma spectrometry and the radon exhalation rate measurements were performed using the dynamic method. Moreover, the Activity Concentration Index (I), introduced by the 2013/59/Euratom Directive, has been used in order to evaluate if concrete samples could exceed the reference level for effective dose due to gamma radiation in building materials. [ABSTRACT FROM AUTHOR]

In the present study the robustness of the etching process used by our laboratory was assessed. The strategy followed was based on the procedure suggested by Youden. Critical factors for the process were estimated using both Lenth's method and Dong's algorithm. The robustness test evidences that particular attention needs to be paid to the control of the etching solution's temperature. [ABSTRACT FROM AUTHOR]

Orvieto (Italy) has a large network of underground tunnels quarried to extract tuff and pozzolana by Etruscans and Romans. One of these tunnels was chosen as natural laboratory to compare different radiation measurement and dose assessment methods. Indeed, tuff and pozzolana are very rich in natural radioactivity and are interesting from the radiation protection point of view since they are still used as building materials. In order to characterize this site an in situ experimental procedure was followed. It consisted in measurements carried out with different instruments: two portable gamma ray spectrometers, two gamma dose rate meters, two radon monitors and one two channel working level monitor. Samples of tuff and pozzolana stones were also collected to be measured with gamma spectrometry in laboratory. Due to the high content of 238 U, 232 Th (more than 200 Bq kg −1 for both radionuclides) and 40 K (more than 2000 Bq kg −1 ) of tuff and pozzolana, elevated levels of exposure to natural radioactivity were found: indeed, with different instruments and approach, a gamma dose rate of about 1 μGy h −1 and an average radon concentration of about 10,000 Bq m −3 , with a Potential Alpha Energy Concentration (PAEC) of 288 MeV cm −3 , were measured. The radiological characteristics of Orvieto underground quarry make it a perfect site for “in field” intercomparisons of different measurement and dose assessment methods. [ABSTRACT FROM AUTHOR]

• Considering reproducibility SSNTDs exhibit better performances than electrets. • The effect of long time sampling (fading) is well managed by the laboratories. • For high and low radon levels, passive devices did not show any fading effect. • For mixed radon/thoron atmosphere: overestimation of radon exposure. • Larger variability of results for mixed radon/thoron atmosphere. [ABSTRACT FROM AUTHOR]