Search

Expansion of high-voltage dc (HVdc) systems to multi-terminal HVdc (MT-HVdc) systems/grids considerably increases the short-circuit levels. In order to protect the emerging MT-HVdc systems/grids against fault currents, proper dc fault current limiters (FCLs) must be developed. This paper proposes an innovative high inductance solid-state dc-reactor-based FCL (HISS-DCRFCL) to be used in HVdc applications. In fact, during the HISS-DCRFCL normal operation, its inductance value is extremely low, and its value becomes considerably high during the fault period, which decreases the fault current amplitude. The proposed HISS-DCRFCL performance is analyzed by MATLAB/Simulink and the simulation results are verified and confirmed by laboratory experimental results using a scaled-down laboratory prototype setup. [ABSTRACT FROM AUTHOR]

Ferroresonance occurrence is a source of damage, causing overvoltage on voltage transformer (VT) and isolators of the grid equipment. Some solutions are available to protect VTs from the ferroresonance overvoltage. However, they just act after the ferroresonance occurrence. In this letter, to prevent the occurrence of ferroresonance, a dc reactor-based protection device is introduced. Analytical studies and simulations by MATLAB/Simulink and Maxwell ANSYS demonstrate the capability of the proposed protection device as a VT ferroresonance inhibitor. Experimental results from a scaled-down laboratory prototype are also provided to verify the proposed solution. [ABSTRACT FROM AUTHOR]

This paper proposes a novel bridge-type solid-state fault current limiter (BSSFCL) based on one series reactor which operates in ac and dc modes. The proposed BSSFCL includes a rectifier bridge with a reactor. This reactor is used as a dc reactor in normal operation mode and as an ac reactor in fault conditions. The advantages of the proposed BSSFCL over the existing dc reactor-type FCLs are its negligible impedance in normal operation mode and its high impedance during a fault interval using simple and novel switching. In other words, during the normal operation mode, the proposed BSSFCL operates in dc mode and in the fault interval, its topology is changed to the ac mode. This switching decreases the switching transient recovery voltage and introduces considerable impedance during the fault period. MATLAB/Simulink software is used for simulations and a prototype is designed and tested for results verification, and to show the performance of the proposed BSSFCL. [ABSTRACT FROM PUBLISHER]